Tray linking does not workThese are possible solutions. Try one or more of the following:L OAD THE SAME SIZE AND TYPE OF PAPER• Load the same size and type of paper in each tray to be linked.• Move the paper guides to the correct positions for the paper size loaded in each tray.U SE THE SAME P APER SIZE AND PAPER TYPE SETTINGS• Print a menu settings page and compare the settings for each tray.• If necessary, adjust the settings from the Paper Size/Type menu.Note: The multipurpose feeder does not automatically sense the paper size. You must set the size from the PaperSize/Type menu.Large jobs do not collateThese are possible solutions. Try one or more of the following:MAKE SURE C OLLATE IS SET TO ONFrom the Finishing menu or Print Properties, set Collate to On.Note: Setting Collate to Off in the software overrides the setting in the Finishing menu.REDUCE THE COMPLEXITY OF THE PRINT JOBReduce the complexity of the print job by eliminating the number and size of fonts, the number and complexityof images, and the number of pages in the job.MAKE SURE THE PRINTER HAS ENOUGH MEMORYAdd printer memory or an optional hard disk.Unexpected page breaks occurINCREASE THE PRINT T IMEOUT VALUE1 Make sure the printer is on and Ready appears.2 On the home screen, touch .3 Touch Settings.4 Touch General Settings.5 Touch the down arrow until Timeouts appears.6 Touch Timeouts.7 Touch the left or right arrow next to Print Timeout until the desired value appears.Troubleshooting261
