EnglishChapter 4 - Administrating Network Printers51Status- - ‘2’NetWare R-Printer Mode Status- - ‘3’EtherTalk Status- - ‘4’EXIT- - ‘0’Type “4” and press the Enter key. Then the currentsettings are displayed.2.Change the settings.OkiPage> set protocol [Enter]<>TCP/IP=1 NetWare=2 EtherTalk=3 EXIT=0 : 3 [Enter]Will you use EtherTalk? (y/n) : y [Enter]Enter “n” if you will not use EtherTalkAppleTalk Zone Name (1-32char) : * [Enter]AppleTalk Printer name (1-32char) : OKIPAGE 14iAre you re-setting? (y/n) : n [Enter]OkiPage> logout (or exit, quit) [Enter]Enter an appropriate command without loggingout, if you want to set other protocols.Setting NetBEUI environmentDisplay/set the NetBEUI environment.DisplayCommand to use:showprotocolorshproTarget account:General users andadministrator userSetCommand to use:set protocol or seproTarget account:Administrator userThe NetBEUI environment has the following items to be set:NetBIOS Computer Name: Set the name of theprinter.NetBIOS Workgroup Name:Specify the workgroupto which the printer belongs.NetBIOS Comment:Set the explanation of the printer.Setting procedureHere, the setting procedure is explained using an example andusing the setting values shown below:NetBIOS Computer name: OP04106CNetBIOS Workgroup name: OKIDATA04106CNetBIOS Comment:OKIDATA Print Server1.Confirm the current settings.OkiPage>show protocol.<>NetWare Q-Server Mode (bindery) Status‘1’NetWare Q-Server Mode (NDS) Status- - ‘2’NetWare R-Printer Mode Status- - ‘3’EtherTalk Status- - ‘4’NetBEUI Status- - ‘5’SNMP Status- - ‘6’EXIT- - ‘0’Type “5” and press the Enter key. Then the currentsettings are displayed.3100euGB.book Page 51 Friday, March 16, 2001 1:18 PM