52OkiLAN 3100e Network Card2.Change the settings.OkiPage>set protocol [RET]<>TCP/IP=1; NetWare=2 ; EtherTalk=3NetBEUI=4; SNMP Trap=5EXIT=0 : 2 [RET]Will you use NetBEUI ? (y/n) : y [RET]Enter “n” if you will not use NetBEUI.Computer Name(1-15char) : OP04106C[RET]W o r k g r o u pn a m e ( 1 - 1 5 c h a r ):OKIDATA04106C [RET]Comment(1-48 char) : OKIDATA PrintServer [RET]Are you re-setting ? (y/n) : n [RET]OkiPage> logout (or exit, quit) [RET]Enter an appropriate command, without logging out, ifyou want to set other protocols.Setting SNMP environmentDisplay/set the SNMP environment.DisplayCommand to use:showprotocolorshproTarget account:General users andadministrator userSetCommand to use:set protocol or seproTarget account:Administrator userThe SNMP environment has the following items to be set:System Contact: Set the contact information of the printer.System Name: Set the name information of the printer.System Location: Set the location information of the printer.Trap Community: Set the Trap Community of the printer.Trap Destination: Set the Trap Destination address of theprinter.Trap Usage: Set the Trap enable or disable.Trap events: Specify the events to send Trap.Setting procedureHere, the setting procedure is explained using anexample, using the setting values shown below:ItemSetting valueSystem Contactwww.okieurope.comSystem NameOKIPAGE 14iSystem Locationconference roomTrap CommunitypublicTrap Destination192.168.0.10000000000-00808704106CTrap events(ALL)3100euGB.book Page 52 Friday, March 16, 2001 1:18 PM
