EnglishChapter 4 - Administrating Network Printers613. Press MENU1 button repeatedly to displayNETWORK. After NETWORK is displayed,press ENTER button.4. TCP/IP is displayed. Press MENU1 buttonrepeatedly to move to NETWARE.5. When you see that the bottom column of the LCDof the NETWARE is ENABLE* (* indicates thatthat value is set), press ON-LINE button withoutdoing anything and exit the menu.6. If the bottom column of the LCD is DISABLE*,press left arrow button or right arrow button tohave ENABLE displayed in the LCD bottomcolumn, then press the ENTER button to haveENABLE* displayed. Then press ON-LINEbutton to exit the menu.7. Now the NetWare is enabled. Setup the printserver and the print queue with utility, etc.Confirming the setting1. Print the menu after completing the setting ofeach item to verify that the setting has been madecorrectly.2. Press ON-LINE button to set the printer to OFF-LINE and hold the Print Menu button for 2seconds or longer. When MENU HP PCL6* isdisplayed, press ENTER button.3. If the set values printed in the menu print are notcorrect, set the values again.Setting EtherTalkTo use this network card in the EtherTalk environment,EtherTalk must be set to ENABLE on the printer’soperator panel.1. Confirm that the printer is in the idle state fromthe LCD panel and the indicator.2. Press ON-LINE button to set the printer to OFF-LINE, and hold MENU1 button for 2 seconds orlonger to display PRINT MODE.3. Press MENU1 button repeatedly to displayNETWORK. After NETWORK is displayed,press ENTER button.4. TCP/IP is displayed. Press MENU1 buttonrepeatedly to move to ETHERTALK.5. When you see that the bottom column of the LCDof the ETHERTALK is ENABLE* (* indicatesthat value is set), press ON-LINE button withoutdoing anything and exit the menu.3100euGB.book Page 61 Friday, March 16, 2001 1:18 PM