Oki OKILAN 3100e User Manual
                                                                                                        | |
Contents
|
60OkiLAN 3100e Network CardBYTE4 using the same procedure above as forSM BYTE1.Setting gateway address1. Following the procedure of “Setting subnetmask” above, press MENU1 button until GWBYTE1 is displayed.2. Change the address by pressing left arrow buttonor right arrow button. (If you hold the button for aseveral seconds, it will expedite the addressupdating.) When the value to be set is displayed,press the ENTER key to finalize it.3. Press MENU1 button to move to GW BYTE2setting. You can set up to and including GWBYTE4 using the same procedure above as forGW BYTE1.4. After setting GW BYTE4, press ON-LINEbutton. It will enable data to be received in TCP/IP. To set NetWare ENABLE/DISABLE rightafter this, press MENU1 button after GW BYTE4is set.Confirming the setting1. Print the menu after completing the setting ofeach address, to verify that the setting has beenmade correctly.2. Press ON-LINE button to set the printer to OFF-LINE and hold the Print Menu button for 2seconds or longer. When MENU HP PCL6* isdisplayed, press ENTER button.3. If the set values printed in the menu print are notcorrect, set the values again.Setting NetWareNetWare enable/disableTo use this network card in the NetWare environment,NetWare must be set to ENABLE on the printer’soperator panel. To set the print server and the remoteprinter, use the utility and the server.1. Confirm that the printer is in the idle state fromthe LCD panel and the indicator.2. Press ON-LINE button to set the printer to OFF-LINE, and hold MENU1 button for 2 seconds orlonger to display PRINT MODE.3100euGB.book Page 60 Friday, March 16, 2001 1:18 PM |
Related manuals for Oki OKILAN 3100e
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine