58OkiLAN 3100e Network CardPrinter settingsFor the basic use of the printer’s operator panel, pleaserefer to the user’s guide for the printer.Please wait for a minimum of 30 seconds before turningthe power off to the printer. It will take about 30seconds for the printer to save a menu change after youexit the menu.If you wish to cancel the menu change, you can exit themenu mode by pressing the ON-LINE button.We recommend that you confirm the contents withmenu print after you make a change in the menu.Note: You can only carry out a network setting ofth e printer when the p rin ter is NOTreceiving any print data.Network enable/disableIn order to connect this network card to network anduse it, Network must be set to ENABLE on the printer’soperator panel. The default setting for NETWORK inthe printer menu is ENABLE* (* indicates that value isset).1. Confirm that the printer is in the idle state fromthe LCD panel and the indicator.Note: Do not set NETWORK to DISABLE* whilstprint data is being received by the printer.2. Press ON-LINE button to set the printer to OFF-L I N E a n d p r e s s M E N U 1 b u t t o n . W h e nPERSONALITY is displayed, press MENU1button repeatedly to display HOST/IF.3. Press ENTER button. PARALL is displayed.Press MENU1 button, to display NETWORK.4. When you see that the bottom column of the LCDis ENABLE*, press ON-LINE button to end themenu setting.5. When you see that the bottom column of the LCDis DISABLE*, press left arrow button or rightarrow button until ENABLE is displayed in theLCD bottom column. Then press ENTER buttonto have the ENABLE* displayed. Then press ON-LINE button to end the menu setting.6. If you do not wish to receive print data from thenetwork, set NETWORK to DISABLE* in theabove procedure.3100euGB.book Page 58 Friday, March 16, 2001 1:18 PM