Contents - Table Of Contents
- okipos x400 programming guide
- selecting protocol control codes
- printing with the parallel port
- printing with the rs232 port
- printer configuration
- command code page reference
- bar codes
- base reference point
- character expansion
- character, fixed spacing
- character pitch
- continuous forms printing
- character, proportional spacing
- copy image area
- cutter command
- peeler command
- form feed
- form overlay recall
- form overlay store
- graphics, custom
- graphics, pcx
- journal print
- lines and boxes
- print darkness
- print length, expanded
- line feed
- media size
- print position
- print quantity
- print speed
- repeat label
- replace data (partial edit)
- reverse image
- rotate, fixed base reference point
- rotate, moving base reference point
- sequential numbering
- start/stop label
- expanded memory option commands
- graphics, custom store
- graphics, custom recall
- graphics, pcx store
- graphics, pcx recall
- area select
- two-dimensional symbols
- configuration commands
- backfeed enable
- calibrate sensor
- custom protocol command codes download
- label tear-off
- print test label
- print darkness fine adjustment
- set rs232 parameters
- set print mode
- set sensor type
- command code quick reference
- bar code symbologies
- industrial two of five
- matrix two of five
- code 128
- custom graphics example
| 
COMMAND DEFAULT NOTEPrint Rotation 0 o (1)Vertical Reference Point 0 (1)Horizontal Reference Point 0 (1)Character Pitch 2 (1)Base Reference Point H=0, V=0 (2)Character Expansion 1 (1)Print Darkness 200 (1)Print Speed 3 ips (2)Notes:(1) The settings for these commands will revert to the default values when the printer receives an Z or an*.(2) These values transmitted with these commands will remain in effect until a new command is received.PRINTER CONFIGURATIONThe OKIPOS X400 printers are different from other OKI models in that they do not use DIP switches for printerconfiguration. Instead, all printer configuration is done via software commands. The parameters that can beconfigured are:z Sensor Calibrationz Protocol Codesz Print Darkness Rangez Sensor Typez RS232 Parametersz Label Tear-Off Positionz Backfeed Enable/DisableBecause there are no DIP switches to indicate the current printer settings, a Test Label can be printed that liststhe active settings in the printer. This Test Label lists all of the information a user needs to ascertain the printerconfiguration. Test Labels can be printed out by sending a command by software (see page 92) or by using theFEED button (see User’s Guide).LABEL SENSINGThe OKIPOS X400 printers can use eye-mark (black bar), gap or notch label sensing. The gap and notch sensoris a transmissive or see-thru type with an infrared light source directed through the label from above anddetected by a separate sensor underneath the label. A reflective sensor is used to detect eye-marks printed on the9 |
