Oki Data CONFIDENTIAL44158801TH Rev.2 162 /6.3.2.4 Motor clutch testThis self-diagnosis is practiced to test motors and clutches.1. Activate the self-diagnostic mode (Level 1), press and hold down the MENU+ or MENU-key, until "MOTOR & CLUTCH TEST" appears in the upper line of the display section, andthen, press the ENTER key. (The MENU+ key increments a test item, and the MENU- keydecrements a test item.)2. Press and hold down the MENU+ or MENU- key, until the item corresponding to the unit ofTable 6-4 now to be tested appears in the lower line of the display section. (The MENU+ keyincrements a test item, and the MENU- key decrements a test item.)3. Pressing the ENTER key initiates the test, causing the unit name to start blinking, and thecorresponding unit is driven for ten seconds (See Figure 6-2).Note! After the unit has been driven for ten seconds, the status of Item 2. above is restored.The unit is driven again when the corresponding switch is pressed again.The clutch solenoid repeats ON/OFF operations in a normal printing drive. (Clutchesthat cannot be driven individually due to their structural reason are driven along withtheir motors.) * "ID UP/DOWN" continues being driven, until the "CANCEL" key isdepressed.The motor keeps rotating if holding down the [ENTER] key for two seconds whendetermining the choice of the motor. (The motor stops when the [CANCEL] key ispressed.)4. Pressing the CANCEL key stops the drive of the corresponding unit. (The indication of thecorresponding unit will be maintained.)5. Repeat Items 2 to 4, as needed.6. To end the test, press the BACK key. (The status of Item 1 will be restored).
