Oki Data CONFIDENTIAL44158801TH Rev.2 170 /<>The same as the key operation of Item . in the execution of BLT REFLECT TEST.4. Repeat Items 2 and 3, as needed.5. Press the [BACK] key to terminate the test. (Status of Item 1 restored)Color registration adjustment test itemsDisplay FunctionREG ADJ EXECUTE Execution of Color registration adjustmentREG ADJ RESULT Viewing of the Color registration adjustment resultBLT REFLECT TEST Execution of the judgment of good or bad Color registrationadjustment belt reflectivityBLT REFLECT RSLT Viewing of the result of judgment of good or bad Color registrationadjustmentbelt reflectivity6.3.2.7 Print density adjustment testThis self-diagnosis is practiced to conduct testing on the Print density adjustment function ofthe printer and to view the execution result. This test is executed also to judge whether the Printdensity adjustment mechanism is normal or abnormal.1. Activate the self-diagnostic (Level 1) mode, and press and hold down the [MENU+] key or[MENU-] key, until the following message appears:2. Pressing the [ENTER] key causes the following message to appear. Press and hold down the[MENU+] key or [MENU-] key, until the intended item is displayed.3. Pressing the [ENTER] key executes the test of the item currently displayed on the panel.<< DENS ADJ EXECUTE is executed>>A density correction test is conducted. ([READY] light blinking)When the test ends, the test result (OK or error name) appears in the upper line of thedisplay section, and **** RESULT, in the lower line.Pressing the [MENU+] key increments the test result sequentially in the display.Pressing the [MENU-] key decrements the test result sequentially in the display.Pressing the [BACK] key restores the status of Item 2.Pressing the [CANCEL] key while the test is under way aborts the test ([READY] lightcomes on) and restores the status of Item 2.
