DMTA-10022-01EN, Rev. C, January 2015Chapter 8146• SINGLE CHAR: Single character command is normally used when anexternal program is controlling the instrument by sending remotecommands that mimic keystrokes.b) In OUTPUT FORMAT, select the format of the data being output (F1, F2,F3,...F10).Contact Olympus for more information on the following communication parameters:• Multi and single character remote commands.• Send formats (F1, F2, F3, F4, F5, F6, F7, F8, F9, and F10).c) Set B-SCAN OUTPUT to ON to output the B-scan data when communicatingwith the GageView interface program. Set it to OFF when communicatingwith other interface programs that do not support the B-scan data. Thisparameter only applies to files that have stored B-scan images.d) Set FTP OUTPUT to 45MG in order to use the 45MG file protocol.ORSet FTP OUTPUT to 38DLP in order to use the 38DL PLUS file protocol.ORSet FTP OUTPUT to MG2 to use the MG2 file protocol.e) Set OUTPUT TYPE to FTP for communication with the GageView softwareusing the standard file transfer protocol.ORSet OUTPUT TYPE to CSV to output in a generic comma-separated variables(CSV) format, which can be integrated into custom software.
