DMTA-10022-01EN, Rev. C, January 2015Chapter 10184Figure 10-17 Saving custom setups5. In the ACTIVE screen, review the setup parameters.6. Press [MEAS] to return to the measurement screen.10.10 Quickly Recalling a Custom Setup for Single Element TransducersNormally, you can change the setup for a custom application by pressing[RECALL XDCR] to select the appropriate setup in the list of available setups), andthen pressing [MEAS]. This process is adequate for typical setups that are changedinfrequently. However, when it is necessary to change between two or more customsetups on a more frequent basis, use the quick setup recall function instead.When the quick setup recall function is activated, a simple keypad shortcut can beused to quickly switch to any of the first four custom setups for single elementtransducers.To activate the quick setup recall function1. In the measurement screen, press [SETUP], and then select MEAS.2. In the MEAS screen, set QUICK SETUP RECALL to ON.3. Press [MEAS] to return to the measurement screen.
