DMTA-10022-01EN, Rev. C, January 2015Using Advanced Gaging Features 1639.4.3 Saving Thickness Readings in the DB GridTo save thickness readings in the DB grid1. Activate and configure the DB grid (see “Activating and Configuring the DBGrid” on page 160).2. Move to the desired DB grid cell (see “Changing the Highlighted Cell in the DBGrid” on page 162).3. In the measurement screen, while the thickness value is displayed, press [SAVE]to save the thickness.The displayed thickness value and setup information are stored at the current IDlocation identified by the highlighted cell in the grid. If the thickness display isblank when you press [SAVE] (Datalogger option only), then “--.---” is saved inplace of a value.The ID number is automatically updated to the next ID number in the sequence.The new ID number is indicated on the ID bar, and its cell is highlighted in thegrid. If the ID number cannot be updated, a long beep sound is emitted and theinstrument displays a message indicating why the ID was unable to update. Inthis case, the ID number on the display remains unchanged.9.4.4 Viewing an Inserted or an Appended Cell in the DB GridIt is possible to insert or append a cell in the DB grid. To maintain the format of thegrid, the inserted or appended cell does not appear until you are on the cell with theinserted point. The file will automatically change to the linear form, and then returnback to Grid view when you increment to the next grid location (see Figure 9-12 onpage 163).Figure 9-12 Example of an inserted cellTo view an inserted or an appended cell in the DB grid1. Activate and configure the DB grid (see “Activating and Configuring the DBGrid” on page 160).Cell with an inserted orappended cell