Preparation19Insert the battery1 Push the catch in the direction shown byarrow to remove the holder.2 Insert the battery with the “+” marked sidefacing up.3 Return the holder to its original position.• When the battery (CR2025) has run out, replaceit with a new one. (The battery lasts about oneyear, depending on the frequency of use.)If the remote control unit fails to work even whenit is operated near the camera-recorder’s remotecontrol sensor, the battery has run out.• Keep the battery out of the reach of children.The remote controlRemote control setupWhen using two camera-recorders simultaneously,set this camera-recorder and the remote controlto either [VCR1] or [VCR2] so the remote controldoes not operate the wrong camera-recorder bymistake.Setting• Wireless remote controlPress the STOP ( ) and STILL ADV ( ) buttonsat the same time to set the remote control unit foruse with VCR1.Alternatively, press the STOP ( ) and STILL ADV( ) buttons at the same time to set the remotecontrol unit for use with VCR2.When the battery in the remote control unit isreplaced, the remote control unit is set for usewith VCR1.• CameraIn the setup menus, OTHER FUNCTIONSscreen, REMOTE, set to VCR1 or VCR2. (Page115)If different settings are used for the camera-recorder and remote control unit, “REMOTE” lightsin red on the viewfinder and LCD monitor.OSDCOUNTER RESET TITLESTILL ADV PAUSE STILL ADVINDEXSELECTSTOREOFF/ONP.B.DIGITALVAR.SEARCHVOL +-PB.ZOOMMENUSETITEMSTOP INDEXMULTI/P-IN-P REC A.DUBPLAY/REW FF/ZOOMDATE/TIME PHOTOSHOTSTART/STOPVCR2 VCR1
