Playback75Frame-by-frame playback (P2 card / Tape)1 Press the button during playback to setthe unit to the pause mode.2 Press the PAGE/AUDIO MON/VAR button toplay frame-by-frame.On the remote control unit, press the STILLADV ( or ) button.• Press and hold the button to perform frame-by-frame play continuously.PAGE/AUDIO MON/VARINDEX STOP INDEXSTILL ADV PAUSE STILL ADVPLAYINDEX STOPV-/REW FF/Camera or Remote controlPress the button to return to normal playback.Clip skip (P2 card)1 During playback, press the button topause the camera.2 Press the (backward) or (forward)button.INDEX STOP INDEXSTILL ADV PAUSE STILL ADVPLAYINDEX STOPV-/REW FF/Camera or Remote controlEnd search (Tape)You can find unrecorded parts or the end of thelast scene shot.1 In the setup menus, OTHER FUNCTIONSscreen, END SEARCH, set the searchmethod. (Page 116)BLANK: Find unrecorded parts.REC END: Find the end of the last scene shot.2 When in the VCR modePress the END SEARCH button.• The unrecorded parts are found, and anunrecorded blank on the tape is found, and astill picture several seconds before the blankis displayed.When in the camera modePress and hold the END SEARCH button forat least a second.• A blank portion of the tape is found, andan unrecorded blank on the tape is found,and the pause status is established severalseconds before the blank.END SEARCH• If you change the tapes, the camera will not beable to find the end of the last scene shot even ifyou have set REC END.• If the tape is blank, searching stops at the end ofthe tape.• This function may not work properly if there areblank parts near the beginning of the tape or partway through the tape.• Before recording, check the still picture first.
