543 When using the phantom microphone,set the INPUT 1/2 (MIC POWER +48V) switchto ON.ON: (When using the phantom microphone)+48V power supply to INPUT 1/2 terminal.OFF: (When a phantom microphone is notconnected)No power supply for INPUT 1/2 terminal.• The battery will discharge faster if you use aphantom microphone.• Set to OFF if you connect equipment notcompatible with +48V. You can damage suchequipment if you leave the setting at ON.4 Use the CH1 SELECT switch to selectthe input signal to be recorded to audiochannel 1.INT (L):Audio from the built-in microphone Lch isrecorded to audio channel 1.INPUT 1:Audio from a device connected to INPUT 1terminal is recorded to channel 1.INPUT 2:Audio from a device connected to INPUT 2terminal is recorded to channel 1.5 Use the CH2 SELECT switch to selectthe input signal to be recorded to audiochannel 2.INT (R):Audio from the built-in microphone Rch isrecorded to audio channel 2.INPUT 2:Audio from a device connected to INPUT 2terminal is recorded to channel 2.• When inputting the microphone signal tochannels 1 and 2, connect the microphone toINPUT 2 and switch both CH1 SELECT and CH2SELECT to INPUT 2.Adjusting the recording levelAUDIO control knobUse the AUDIO control knob to adjust therecording level of the built-in microphone or ofaudio signals input through the INPUT 1/2 (XLR3-pin) terminal.To adjust the volume of the sound for monitoring.(Page 46)To adjust the recording level of the audio signals,turn the AUDIO control knob while referringto the audio level meter at the bottom left ofthe viewfinder and LCD monitor, regardless ofthe MIC ALC option setting (page 107) on theRECORDING SETUP screen of the setting menu.• There may be a slight difference in the volumelevel between the P2 mode and TAPE mode.The audio signals input into AUDIO IN/OUT CH1/CH2 (pin jack) terminals can not be adjusted.Check the recording volume level prior to shooting.• For P2 mode recording, the recording level isset higher than for Panasonic’s broadcast-usecamera recorders (AJ series).Switching Audio Input (continued)
