90Analog input (Tape)Video contents on S-VHS (VHS) cassettes can becopied to tape, and TV programs can be recorded.• Set the MEDIA switch to the TAPE position.(Page 29)1 Connect this unit to a video deck or atelevision. (Page 80)2 Press the mode button on the unit to switchto the MCR/VCR mode.VCRDUBMCRPCCAMERA3 Set the external device to playback.4 Press the two REC buttons simultaneously.On the remote control, while pressing the RECbutton, press the PLAY button.COUNTER RESET TITLESTILL ADV PAUSE STILL ADVINDEXÐ VOL +STOP INDEXMULTI/P-IN-P REC A.DUBPLAY/REW FF/ZOOMRECCamera or Remote control• When you press these two buttonssimultaneously in the playback pause status,the unit is set to recording standby status.Each time you press the button, the statusswitches between recording and recordingstandby.To stop the dubbing, press the button.• Stop playback on the external unit.• You cannot adjust the audio level.• Analog signals cannot be input in the P2 mode.TAPEAnalog/digital (AD) conversion (VCR mode only)You can use this unit to convert analog to digitalsignals. In the setup menus, AV IN/OUT SETUPscreen, set 1394 OUT to “ON”. (Page 112)This enables you to output digital images, whichwere input as analog signals from an external unit,through this unit’s 1394 connector to another digitalvideo unit.• Normally, set 1394 OUT to “OFF”. Images maybe disrupted if you set it to “ON”.• You can also use the S-video cable.Video deck, etc.Analog signalsThiscamera-recorderDigital signalsOther digital video unitDubbing (continued)
