21Setup (Initial Settings)SET–UP MENU 2 NOFACTORYUSER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to move the cursor to FACTORY, andpress the SET button.O If the cursor is moved to FACTORY and thisoperation is performed, the factory settings arerestored for all the menus with the exception ofthe SYSTEM menu.O If the cursor is moved to NO and this operationis performed, operation returns to the menuscreen without restoring the factory settings.4 Press the MENU-UP button or MENU-DOWNbutton to move the cursor to USER (ALL), andpress the SET button.O If the cursor is moved to USER (NOTSYSTEM) and this operation is performed, thesettings are updated for all the menus with theexception of the SYSTEM menu.O If the cursor is moved to NO and this operationis performed, operation returns to the menuscreen without updating the settings.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.This completes the menu settings.5Set the LOCAL/MENU/REMOTE switch to theLOCAL or REMOTE position.This completes the menu settings.7SET–UP MENU 2 NOUSER (ALL)USER (NOT SYSTEM)Press the MENU-UP button or MENU-DOWNbutton to move the cursor to the SAVEposition, and press the SET button.The VTR is set to the SAVE mode, and the SAVEscreen is displayed on the video monitor.4SAVE OK?2 NOYESThe screen on which SAVE is checked nowappears. Press the MENU-UP button orMENU-DOWN button to move the cursor tothe YES position, and press the SET button.The settings are now stored in the memory.6How to set the user defaultsSet the LOCAL/MENU/REMOTE switch to theMENU position.The VTR is set to the menu setting mode, andthe menu screen is displayed on the videomonitor.1Perform steps 2 through 6 in “How toperform settings using the on-screen menu,”and change to the desired settings.2Press the RESET button.The VTR is set to the default setting mode, andthe default setting screen is displayed on thevideo monitor.3SELECT MODE2 0 ESCAPE1 LOAD2 SAVE3 PROTECTPress the MENU-UP button or MENU-DOWNbutton to move the cursor to the LOADposition, and press the SET button.The VTR is set to the LOAD mode, and theLOAD screen is displayed on the video monitor.3
