30500 VITC BLANK00000001BLANKTHRUFor setting whether to output the VITC signal to the position set by menuitem No.501 (VITC POS-1) and No.502 (VITC POS-2).0: The VITC signal is not output.1: The VITC signal is output.This setting is only effective for SD outputs (VIDEO output and SD SDIoutput).501 VITC POS-1 0000:0006:001010L:16L:20LFor setting the position where the VITC signal is to be inserted.O The same line as that set for menu item No.502 (VITC POS-2) cannotbe set.O This setting is only effective for SD outputs (VIDEO output and SD SDIoutput).502 VITC POS-2 0000:0008:001010L:18L:20LFor setting the position where the VITC signal is to be inserted.O The same line as that set for menu item No.501 (VITC POS-1) cannotbe set.O This setting is only effective for SD outputs (VIDEO output and SD SDIoutput).503 REGEN00000001REGENPREFor setting the synchronization method of the internal time code generator.0: The time code reader is synchronized to the time code which is readfrom the tape.1: The synchronization method can be preset by a front panel operation orusing the remote controller.504 RUN MODE00000001RECFREEFor setting the operation mode in which the internal time code generatoradvances the time code.0: The generator advances only during recording.1: It advances while the power is on regardless of the operation mode.505 TCG REGEN000000010002TC&UBTCUBFor setting the signal to be regenerated when the TCG (time codegenerator) is in the regeneration mode.0: Both the time code and user’s bit are regenerated.1: Only the time code is regenerated.2: Only the user’s bit is regenerated.509 PHASE CORR00000001OFFONFor setting whether to control the phase compensation for the LTC outputduring playback.0: The phase compensation is not controlled.1: The phase compensation is controlled.508 BINARY GP00000001000200030004000500060007000001010011100101110111For setting the conditions under which the user’s bit in the time codegenerated by TCG is to be used.0: Not specified (character set is not specified).1: ISO characters (8-bit character set compliant with ISO646, ISO2022)2: Unassigned 1 (not defined)3: Unassigned 2 (not defined)4: Unassigned 3 (not defined)5: Page/line6: Unassigned 4 (not defined)7: Unassigned 5 (not defined)TIME CODEItem SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settingThe underlining denotes the factory mode.Setup Menus
