25O If the PAGE button and the DATA+ or DATA– button are pressed together when menu item No.007(CHARA H-POS) and No.008 (CHARA V-POS) are being set, the counter display appears temporarilywhile these buttons are held down to enable the settings to be checked.It is also possible to use the DATA+ button and DATA– button while holding down the PAGE button toperform the settings while at the same time checking their actual status.O Even when “OFF” is selected as the menu item No.005 (SUPER) setting, the superimposing isdisplayed in accordance with the menu No.006 (DISPLAY SEL) setting while the menu settings arebeing performed. When the menu setting process is exited, the display accords with the menu itemNo.005 (SUPER) setting.001 LOCAL ENA000000010002DISST&EJENAFor setting the buttons which can be operated on the front panel when theLOCAL/MENU/REMOTE switch is at the REMOTE position.0: No buttons can be operated.1: Only the STOP and EJECT buttons can be operated.2: All the buttons can be operated except for COUNTER and RESET.002 TAPE TIMER00000001±12h24hFor setting the time system on the CTL counter display.0: 12-hour system1: 24-hour system003 REMAIN SEL0000000100020003OFF2L1LR/TTLFor setting the superimposing of the remaining tape time and total tapelength displays for the VIDEO OUT2 connector.0: No superimposed displays1: Remaining tape time is displayed on the second line.2: Remaining tape time is displayed on the first line.3: Remaining tape time is displayed on the first line and the total tapelength on the second line.O When “2L” has been selected as this item’s setting, the time will not bedisplayed even if “TIME” was selected as the menu item No.006(DISPLAY SEL) setting.O Even when “R/TTL” has been selected as this item’s setting, the totaltape length will not be displayed if “TIME” has been selected as themenu item No.006 (DISPLAY SEL) setting.005 SUPER00000001OFFONFor setting whether the displays are to be superimposed onto the VIDEOOUT2 connector.0: The displays are not superimposed.1: The displays are superimposed.006 DISPLAY SEL000000010002TIMET&STAT&S&MFor setting what displays are to be superimposed onto the VIDEO OUT2connector.0: Only the time display is superimposed.1: The time and operation status are superimposed.2: The time, operation status and mode are superimposed.When “T&S&M” has been selected as this item’s setting and a warning orerror occurs, an error message is superimposed.007 CHARA H-POS 0000:0006:00370:6:37For setting the horizontal position where the superimposed display is toappear.008 CHARA V-POS 0000:0023:00320:23:32BASICItem SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settingThe underlining denotes the factory mode.Setup MenusFor setting the vertical position where the superimposed display is toappear.
