10Connector areaParts and Their FunctionsPin No. Signal1 Frame Ground2 Transmit A3 Receive B4 Receive Common56 Transmit Common7 Transmit B8 Receive A9 Frame Ground1 695Pin No. Signal12 Set Up3 C Level4 Ground5 +9 V6 System H7 SYS. SC. Coarse (2)8 –9 V9 Hue10 Video Level11 Ret Ground121314 SYS. SC. Fine15 SYS. SC. Coarse (1)18915? Fan motorThis motor drives the fan to cool down the unit.@ GripGrips are provided on the side panels. However,when the unit is to be operated, lay it flat.A Slot for SDI card (option)This is the slot for the optional component serialinterface board (SDI input/output board: model AJ-YA95P).6 VIDEO MONITOR OUT connectorThis is the output connector for the video monitorsignals. Superimposed video signals can be outputto this connector.Superimposing can be set to ON or OFF by setupmenu item No.002. (See page 29)7 VIDEO IN and OUT connectorsThese are the input connector and outputconnectors for the analog composite video signals.8 AUDIO OUT (CH1/CH2) connectorsThese are the output connectors for the analogaudio signals.9 AUDIO IN (CH1/CH2) connectorsThese are the input connectors for the analog audiosignals.: REF VIDEO IN connectors and 75 Ω terminationswitchThese are the input connectors for the referencevideo signals.Input black burst signals or composite video signalswhich comply with the RS-170A standard.Set the switch to ON for termination.; TC IN connectorThis is the connector for recording the external timecodes on the tape.< TC OUT connectorDuring playback, the playback time code is outputto this connector. During recording, the time codegenerated by the internal time code generator isoutput.= REMOTE CONTROL connectorThis unit can be operated from an external sourceby connecting an optional external remote controller(model AJ-A95P) to this connector.OSet the LOCAL/MENU/REMOTE switch to theREMOTE position.OThis complies with the RS-422A interfacestandard but the functions associated with editingdo not work.> ENCODER REMOTE connectorAn optional external encoder remote controller(model AU-ER65B) is connected to this connectorwhen the video output signal settings are to beadjusted from an external source.Set setup menu item No.00 to REMOTE.(See page 27)