Panasonic AJ-DCP Operating Instructions Manual

33500 VITC BLANK00000001BLANKTHRUFor setting whether the VITC signal is to be output to the composite videooutput.0: VITC signal is not output.1: VITC signal is output.505 TC PRESET For setting the time code value when P-REC or P-FREE has been selectedas the TCG mode setting by the menu item No.504 (TC MODE).After the + or – button is pressed, select the digit to be changed using theUP or DOWN button, and then change the value using the + or – buttonagain.506 UB PRESET For setting the user’s bit value when P-REC or P-FREE has been selectedas the TCG mode setting by the menu item No.504 (TC MODE). After the +or – button is pressed, select the digit to be changed using the UP orDOWN button, and then change the value using the + or – button again.508 PHASE CORR00000001OFFONFor setting whether to control the phase compensation of the linear timecode which is generated by the TCG.0: No phase correction control is exercised.(LTC phase correction bit: 0)1: Phase correction control is exercised.(LTC phase correction bit: 1)507 BINARY GP00000001000200030004000500060007000001010011100101110111For setting the usage status of the user’s bit which is generated by theTCG.0: NOT SPECIFIED (character set is not specified)1: ISO CHARACTER (8-bit character set complying with the ISO-646 orISO-2022 standard)2: (Undefined)3: (Undefined)4: (Undefined)5: PAGE/LINE(page/line multiplexing system complying with SMPTE262M standard)6: (Undefined)7: (Undefined)501 VITC POS-1 00000006001010L16L20LFor setting the position where the VITC signal is to be inserted.(The same line as the one used for VITC POS-2 cannot be set.)502 VITC POS-2 00000008001010L18L20LFor setting the position where the VITC signal is to be inserted.(The same line as the one used for VITC POS-1 cannot be set.)503 TCG REGEN000000010002TC&UBTCUBFor setting the signal which is to be regenerated when the time codegenerator (TCG) is in the regeneration mode.0: Both the time code and user’s bit are regenerated.1: Only the time code is regenerated.2: Only the user’s bit is regenerated.504 TC MODE00000001000200030004P-RECP-FREEI-REGE-VITCE-LTCFor setting the TCG mode.0: The time code is counted up simultaneously with the recording.1: The time code is counted up irrespective of the VTR mode.2: The time code is counted up in such a way that it follows on the tape.3: The mode is synchronized with VITC which is superimposed onto thevideo input.4: The mode is synchronized with LTC in the TC input.TIME CODE menuItem SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settingThe underlining indicates the factory setting.Setup Menus