29O If the PAGE button and DATA+ button or DATA– button are pressed when the CHARA H-POS orCHARA V-POS item has been set, the counter display appears temporarily while this button is helddown to enable the setting to be checked.Even while the PAGE button is pressed, the settings can be performed using the DATA+ button orDATA– button while the actual status is checked.000 LOCAL ENA000000010002DISST&EJENAFor setting the switches which can be operated on the front panel when theREMOTE/LOCAL switch has been set to REMOTE.0: None of the switches can be operated.1: Only the STOP and EJECT switches can be operated.2: All operations are possible except for the COUNTER button and RESETbutton.001 TAPE TIMER00000001±12h24hFor setting the CTL counter to the 12-hour or 24-hour display system.0: 12-hour display system1: 24-hour display system002 SUPER00000001OFFONFor setting whether to display the time code, etc. onto the video monitoroutput by superimposing it.0: Superimposed data is not displayed.1: Superimposed data is displayed.003 DISPLAY SEL0000000100020003TIMET&STAT&RT&S&RFor setting what is to be displayed by superimposing onto the video monitoroutput.0: Only the time is displayed.1: The time and operation status are displayed.2: The time and amount of remaining tape are displayed.3: The time, operation status and amount of remaining tape are displayed.004 CHARA H-POS 000000040008048For setting the character position in the horizontal direction for thesuperimposed display.005 CHARA V-POS 00000022022006 CHARA TYPE00000001WHITEW/OUTFor setting the type of superimposed display and menu display.0: White characters are displayed on a black background.1: White characters with black borders are displayed.007 SYS FORMAT0000000150M25MFor setting the unit’s recording and playback format.0: 50 Mbps mode1: 25 Mbps mode008 PB FORMAT00000001MANUALAUTOFor setting the format during tape playback.0: Setting is based on the setting selected for menu item No.007 (SYSFORMAT).1: Setting is based on the format recorded on the tape.BASIC menuItem SettingNo. Superimposeddisplay No. SuperimposeddisplayDescription of settingThe underlining indicates the factory setting.Setup MenusFor setting the character position in the vertical direction for thesuperimposed display.A setting from 0 to 18 is valid in the T&S&R mode (3-line display).A setting from 0 to 20 is valid in the T&STA mode or T&R mode (2-linedisplay).