114 Editing: Setting Audio LevelSetting Audio LevelA fixed or variable audio level can be set for a specified section of the playlist. Review or playlist playback occurs at the setaudio level while Edit Copy generates material at the set audio level.The audio level can be bet set when registering an event or for a specific audio section of already existing playlist.◆ NOTE:• The level setting is stored in memory, which limits capacity (time).Estimate: About 10 minutes per channel(Depends on level changes)Any settings that exceed the limit disable the setting.When registering a new event in a playlist, set a constantaudio level for the registered audio event.1 Assign IN and OUT points to enable eventregistration.➝Refer to “Registering Events in a Playlist” (page 97).2 Set the AUDIO VOL SEL switch to PB.3 Adjust the audio level using the audio level controls.4 Use the REC button or PREVIEW button to registerthe event.This operation registers the event and an iconindicating that a constant audio level setting has beenmade appears on the event on the timeline.5 Check audio level by performing a review or playlistplayback.Check events for which a level has been set by pressing thePLAY button or REVIEW (SHIFT + PLAY) button.◆ NOTE:• The audio level is not set if no new event has been registered in thechannel selected in step 2.• If the level value is a UNITY value, the icon indicating a level settingdoes not appear.• To move the audio volume control during a preview, refer to“Changing Audio Level in an Event during Event Registration” (page115).• This method for setting the audio level is not available for a hard diskor an external device used as a player.Setting a Constant Audio Level forthe Entire Event during EventRecording2 4 5 43
