222 For Long and Trouble-Free Operation: Error MessagesThe following lists major warning messages displayed on the LCD monitor. For details on other warning messages, follow theinstructions given in the messages.■ Error indicationThese messages appear when malfunctions occur with the unit or an SD memory card. If the problem cannot be solved byturning the unit off and turning it back on, try replacing the card as directed, or consult your supplier.Continuous playback of multiple clips may not be smooth in the transition between clips.In the following cases, playback may stop briefly in the transition between clips during continuous playback of multiple clips.■ Multiple recording formatsRecording mode = PH modePlayback format = 1080/60i (30P)AVCHD warning information (when the AJ-YCX250G AVCHD codec board (optional) isinstalled)Message DescriptionCANNOT BE USED DUE TO INCOMPATIBLE DATA. This data conforms to a different standard and cannot be used.CANNOT PLAY. Cannot play.CANNOT SELECT MORE CLIPS. Too many clips selected to delete.CANNOT SET. THE NUMBER OF INDEXES HAS EXCEEDED THEMAXIMUM LIMIT.Cannot make settings since the number of indexes exceeds the limit.CARD ERROR. PLEASE REFORMAT. Formatting failed. This card must be reformatted.CHECK CARD. Check the card.CONTROL DATA ERROR HAS BEEN DETECTED. A control data error was detected.NO CARD No card is inserted.NO FILE. The metadata file cannot be found.REPAIR CLIP? Repair clip?THE CLIP IS PROTECTED. PLEASE CANCEL PROTECTION. The clip is protected. Cancel protection.THUMBNAIL DATA ERROR IS DETECTED. A thumbnail data error was detected.UNABLE TO FORMAT. Cannot be formatted.WRITE PROTECT The card is write protected.Message DescriptionCANNOT RECORD Indicates that an error occurred during shooting.REC WARNING Indicates that an error occurred during recording. Rerecord the card. If the warning still persists, contact yoursupplier.Turn the power off if the warning continues.SYSTEM ERRORTURN POWER OFFIndicates that a system error occurred. Turn the power off and then turn it back on again.If this message occurred during SD memory card access, for example when a clip was deleted, the SDmemory card may be damaged. Replace the SD card with a new one.Use the AVCCAM Restorer, a repair utility, if this message is output during a repair.➝ Refer to “Recovery of SD memory cards” (page 160).Recording formatPH 1080/60iRecording formatPH 1080/60iRecording formatPH 720/60PRecording formatPH 1080/60iPlays back smoothly. This format does not matchthe playback format and willnot be played back.Video stops briefly duringthe switch between clips.
