180 Setup: Item SettingsVideo Output Signal AdjustmentsThe control matrix for adjustments is shown below.When CMPNT is selected in setup menu No. 650 (STYLE)This unit:Only setup menu adjustments are available.External encoder remote controller/this unit:External encoder remote controller and setup menuadjustments are available.When CMPST is selected in setup menu No. 650 (STYLE)This unit:Only setup menu adjustments are available.External encoder remote controller/this unit:External encoder remote controller and setup menuadjustments are available.This menu sets buttons available on the key panel in REMOTE mode, switches display of the CTL counter display between 12and 24-hour clock display, sets superimposed display, character displays in superimposed display, setup menu and otherdisplays, sets recording formats, sets the formats that can be added to the playlist and sets the time of the internal clock.• XX indicates factory default settings.Setting Adjustment05: ENCODER SEL 653: Y LVL654: Pb LVL655: Pr LVL656: BK LVLLOCAL This unitBOTH External encoder remote controller/this unitSetting Adjustment05: ENCODER SEL 662: V LEVEL663: C LEVEL664: HUE/C PHASE665: SETUP/BK LVLLOCAL This unitBOTH External encoder remote controller/this unitBASICItem SettingSettings and brief function descriptionFRNo.SUPERDISP.FRNo.SUPERDISP.001 LOCAL ENA000000010002DISSTOPENARestricts the number of buttons on the key panel that are available when the REMOTE/LOCAL switch is set to REMOTE.0: No buttons are available.1: Only the STOP button is available.2: All buttons are available.002 CTL DISP00000001±12h24hSwitches the CTL counter display between 12 and 24-hour clock display.0: 12-hour clock display1: 24-hour clock display003 REMAIN SEL0000000100020003OFF2L1LP2&SDSpecifies whether to display the remaining time or total time via superimposed display.0: No display.1: The second line shows remaining time and total time of the P2 card.2: The first line shows remaining time and total time of the P2 card.3: The first line shows remaining time and total time of a P2 card, the second line showsremaining time on an SD memory card.NOTE:• These functions are not displayed when “2L” is selected and “TIME” is set in setupmenu No. 006 (DISPLAY SEL).• Total tape time is not displayed when “P2&SD” is selected and “TIME” is set in setupmenu No. 006 (DISPLAY SEL).• In the following cases, the remaining time is shown on the second line when a settingother than OFF is selected.- When setup menu No.040 (VFR REC) is set to ON- When setup menu No.041 (LOOP REC) is set to ON- When setup menu No.155 (AUTO REC) is set to something other than OFF so thatrecording and stopping can be performed automatically• The remaining time for P2 cards is not displayed when no P2 card has been inserted.• The remaining time for SD memory cards is not displayed when an AJ-YCX250GAVCHD codec board (optional) has not been installed or an SD memory card has notbeen inserted.
