164 Maintenance and Inspections: Warning SystemWarning and Error Display for Thumbnail Operation and USB HOST MODEItem Message Description MeasureThumbnailsCANNOT ACCESS! Data cannot be accessed because it is corruptedor for other reasons.Restore media and clips to normal state beforeaccess.WRITEPROTECTED!The P2 or SD card is write protected. Insert write-enabled media.CARD FULL! The P2 or SD card is full. Insert media with sufficient capacity.NO CARD! No P2 or SD card is inserted. Insert compatible media.NO FILE! The designated file is not found. Check the file.CANNOT COPY! Images cannot be copied. Check the conditions for copying.CANNOT DELETE ! Contents version mismatch prevents deletion. Match devices and contents version.UNKNOWNCONTENTSFORMAT!Warning displayed to indicate contents versionmismatch.Match devices and contents version.CANNOT FORMAT! P2 card problem prevents formatting. Check P2 card.CANNOT REPAIR! Data cannot be repaired since content thatcannot be repaired is selected.Check selected content.CANNOT RE-CONNECT!A clip that does not span multiple P2 cardscannot be reconnected.Check selected content.INVALID VALUE! Entered data was invalid. Enter data in a valid range.UNKNOWN DATA! The metadata character code is invalid. Use UTF-8 for the metadata character code. Usethe viewer to enter correct characters.CANNOT REPAIR INSELECTION!Some of the selected clip could not be repaired.NO SD CARD! No SD card is inserted. Insert an SD card.NO COPY TO SAMECARD!A clip cannot be copied to the card storing theoriginal clip.Copy the selected clip to a card that does notcontain the original clip.SAME CLIP ISSELECTED!The clip cannot be copied because a clip that hasalready been copied and the original clip havebeen selected.Confirm the selected clip and release either thesource clip or the destination clip and thenexecute the copy operation.USER CLIP NAMEMODIFIED!Characters in the clip name had to be deleted inadding the counter value.The user clip name plus the counter value canonly contain up to 100 bytes. Characters in theclip name are automatically deleted when thetotal exceeds 100 bytes.TOO MANY CLIPS! Too many clips are selected. Reduce the number of selected clips.LACK OF RECCAPACITY!There is not enough recording capacity left on thecard.Insert a card with sufficient recording capacity.CANNOT CHANGE! Any thumbnails that cannot be produced on theAVC-Intra100 or AVC-Intra50 and displayed ingray cannot be changed at the text memoposition.Set SYSTEM MODE according to the clips.MISSING CLIP! A shot mark will be added to the clips recordedon multiple P2 cards when all P2 cards are notinserted yet.Insert all P2 cards with recorded clips, andconfirm that the incomplete clip indicatorsdisappear, and then add shot marks.SoftkeyboardCANNOT CHANGE! [PERSON] will be entered while the text memo isnot available.Enter [TEXT] before entering [PERSON].CANNOT SET!INVALID VALUE!The entered value is incorrect. Change the value.!"#$%&'())*#+,-.+/012345677899./O9:;<99=>>?@A>BACDEFGDEHIJKL?M
