171Menu: Menu Description TablesMenuItems/Data SavedAdjustableRange RemarksUSR SW F.RATE (1080-59.94i,1080-23.98PsF,1080-24PsF)1FRAME:24FRAME:30FRAME(1080-50i)1FRAME:25FRAMEWhen the FRATE function has beenassigned to a user button, the startingframe rate under VFR operation is set.When the mode has been changedusing other settings and the frame ratevalue set here exceeds the maximumframe rate allowed by the set mode, themaximum frame rate is changed to themaximum frame rate of the set mode.S C U F RSCAN REVERSE ONOFFThis setting is for correcting an imagewhich has been inverted by a film-uselens or anamorphic lens attached to theunit.S C U F RPC MODE SEL USB HOSTUSB DEV.This is for setting the operations mode ofthis unit when PC MODE is set to “ON”and an external device is connected tothe USB connector.USB HOST:Allows data transfer from the unitto the USB-connected device.USB DEV.:Allows data transfer from theUSB-connected device to theunit.#NoteWhen the PC MODE menu option is setto “ON”, no change can be made to thisoption.– – – F –PC MODE ONOFFUsed to enable or disable the mode thatallows the unit to be connected to a PCor an external hard disk drive viaUSB 2.0.ON: Sets the unit to the modeselected through the PC MODESELECT menu option.OFF: Disables the PC MODE fornormal operation.#NoteOnce the power is turned off, the optionis always set to “OFF” when the power isturned on next time.– – – F –OPTION MODEItems/Data SavedAdjustableRange RemarksACCESS LED OFFSLOT SIDELCD SIDEBOTHSpecify whether or not to enable the P2card access LEDs.OFF: Disables both LEDs above theslots and on the side panel.SLOT SIDE:Enables the LED above the slotsand disables the LED on the sidepanel.LCD SIDE:Enables the LED on the sidepanel and disables the LEDabove the slots.BOTH: Enables both LEDs above theslots and on the side panel.– C U F –P.OFF GPSDATAHOLDCLEARSelect whether or not to hold the UMIDGPS position information while thepower is turned off, thereby keeping thisinformation as status data holding theprevious value until the power is turnedon again, which enables a newmeasurement to start.HOLD: Hold and save the data.CLEAR: Clear the data when the power isturned off, and save zero (No-Info) from the next power-onuntil a new measurement iscompleted.– C U F –SDI METADATA ONOFFUsed to specify whether or not to outputmetadata (UMID) to HD SDI.– C U F –SAVE SW (AUDOUT)ONOFFSelect whether or not to forcibly disablethe audio output when the SAVE ON/OFF switch is set to [ON].ON: Disable audio output.OFF: Enable audio output.– C U F –SAVE SW (LCD) ONOFFSelect whether or not to automaticallyturn off the LCD monitor when the SAVEON/OFF switch is set to [ON].ON: Turn off LCD monitor.OFF: Do not turn off LCD monitor.– C U F –!"#$%&'())*#+,-.+/012345677899.(.9:;<99=>>?@A>BACDEFGDEHIJKL?M
