| 
Setting/releasing the limitersBasic limiter operations1. Press the Tap the button (rather than pressing it). When it is pressed for 2seconds, the camera menu will appear.If this happens, press the clear the camera menu.Then start again from step 1 .2. Press the <4 / 5/ b / a> button for 2 seconds whileholding down the button.The limiter for the upper limit, lower limit, left limit or right limit is set(or released) using these direction buttons, respectively. The tallylamp will blink at this time. When a limiter is set, it blinks once; when alimiter is released, it blinks twice.If any other button was operated between steps 1 and 2 , start againfrom step 1 .Setting the limitersThe limiter positions can be set by following the steps below.When the position is set, the tally lamp blinks once.1. Press one of the to button to select theunit.• Setting the upper limit position of the movement rangePress the <4> or <5> button of the wireless remote control toturn the unit as far as the position which will serve as the upperlimit.Next, perform the steps in “Basic limiter operations”.(Press the 4>button for 2 seconds while holding down the button.)• Setting the lower limit position of the movement rangePress the <4> or <5> button of the wireless remote control toturn the unit as far as the position which will serve as the lowerlimit.Next, perform the steps in “Basic limiter operations”.(Press the 5>button for 2 seconds while holding down the button.)• Setting the left‑most limit position of the movement rangePress the < b > or < a > button of the wireless remote controlto turn the unit as far as the position which will serve as theleft-most limit.Next, perform the steps in “Basic limiter operations”.(Press the < b > button for 2 seconds while holding down the button.)• Setting the right‑most limit position of the movement rangePress the < b > or < a > button of the wireless remote controlto turn the unit as far as the position which will serve as theright-most limit.Next, perform the steps in “Basic limiter operations”.(Press the < a > button for 2 seconds while holding down the button.)Releasing the limitersThe limiter positions that are set can be released by following the stepsbelow.When the position is released, the tally lamp blinks twice.1. Press one of the to button to select theunit.2. Release the limiters by taking the steps below.• Releasing the upper limit position of the movement rangePerform the steps in “Basic limiter operations”.(Press the 4>button for 2 seconds while holding down the button.)• Releasing the lower limit position of the movement rangePerform the steps in “Basic limiter operations”.(Press the 5>button for 2 seconds while holding down the button.)• Releasing the left‑most limit position of the movement rangePerform the steps in “Basic limiter operations”.(Press the < b > button for 2 seconds while holding down the button.)• Releasing the right‑most limit position of the movement rangePerform the steps in “Basic limiter operations”.(Press the < a > button for 2 seconds while holding down the button.)Resetting the limitersTo reset the limiters, the currently established settings must be released.The limiter positions that are set can be reset by following the stepsbelow.1. Release the settings of the limiter positions to be resetby following the steps in “Releasing the limiters”.2. Set the limiter positions by following the steps in“Setting the limiters”.132 |
