Panasonic AW-UE150WP Operating Instructions Manual

Also see for AW-UE150KE: Operating instructions Operating instructions Operating instructions Operating instructions

Contents

12 V INIR ID AUDIO INRS-422SERVICEMONI OUT 12G SDI OUT3G SDI OUT G/L INLANLINK ACTSFP+14G FIBER1234567586239 10 11 12 1421 2220191817161513Rear panelBottom panel1. Mount bracket for installation surface (suppliedaccessory)Mount this bracket onto the installation surface, and then attach thecamera main unit to the bracket.2. Drop‑prevention wireThis wire is screwed down to the bottom panel of the camera mainunit. Loop the circle part of the wire around the hook of the mountbracket.3. Status display lampThis lights in the following way depending on the status of the unit.Orange: When the standby status is establishedGreen: When the power is onRed: When trouble has occurred in the unitGreen and blinks twice:When a signal matched by the remote control ID hasbeen received from the wireless remote control (optionalaccessory) while the power is onOrange and blinks twice:When a signal not matched by the remote control ID hasbeen received from the wireless remote control (optionalaccessory) while the power is onRed and blinking:Firmware being updated4. Tilt headThis rotates in the right and left direction.5. Wireless remote control signal light‑sensing areaThe light-sensing area is provided in three places, on the front panelof the camera pedestal and at the top of the rear panel.6. Hole for securing the camera pedestalThis hole is provided in the bottom panel of the camera pedestal.7. Camera headThis rotates in the up and down direction.8. Tally lampThis comes on or goes off in response to the control from thecontroller but only when “On” has been selected as the tally lamp usesetting. The tally lamp is red or green.9. LAN connector for IP control This LAN connector (RJ-45) is connected when exercising IP controlover the unit from an external device. Use a cable with the followingspecifications for the connection to this connector.When using a PoE++ Ethernet hubLAN cable (category 5e or above, straight cable or cross cable),max. 100 m (328 ft)When not using a PoE++ Ethernet hubLAN cable (category 5 or above, straight cable),max. 100 m (328 ft)Parts and their functionsCamera unit17