Panasonic DMR-ES40VS Operating Instructions Manual

Also see for Diga DMR-ES40V: Quick setup guide

Contents

Panasonic DMR-ES40VS Operating Instructions Manual Manual pdf 19 page image

Getting started19VQT0R73You do not have to change the setting when connected to a 4:3standard aspect TV that is not compatible with progressive output.(l 58)[1] While stoppedPress [FUNCTIONS].[2] Select “Other Functions” with [3, 4] and press[ENTER].[3] Select “SETUP” with [3, 4] and press [ENTER].[4] Select “TV Screen” with [3, 4] and press[2, 1].[5] Select “TV Type” with [3, 4] and press[ENTER].≥Aspect 4:3/Aspect 16:9:≥480p/480i:Select “480p” if the TV is compatible with progressive output.[6] Use [3, 4] to select the item and press[ENTER].When progressive output is selected, the following screenappears:≥When progressive output is selected, you will not be able tosee the picture unless the TV is connected to theCOMPONENT VIDEO OUT terminal on this unit. This is not amalfunction.(1) Select “Yes” with [2] andpress [ENTER].≥A confirmation screenappears.(2) Press [ENTER].To change to interlace≥When the picture is distorted, press and hold [CANCEL/RESET, ¢] until the picture is displayed correctly.∫ To return to the previous screenPress [RETURN].∫ To exit the screenPress [RETURN] several times.Connection (without Audio/Video cable) onlyIn some cases, there may be interference (lines or patterning) ora very poor picture on the TV when the DVD Recorder isconnected. If this happens, follow the steps below to changethe video playback channel (RF output channel). This willremove the interference.[1] Press [FUNCTIONS] formore than 5 seconds.The RF output channel number isdisplayed on the unit display.[2] Press [CH, W, X] to selecta channel number (CH3 orCH4).The unit’s displayEach time you press the button:CH3 (Default setting) (# CH4 (# OFF^-----------------------------------------------J≥Set the RF output channel of the DVD Recorder to “OFF”(RF OFF) when the DVD Recorder is connected to a TV via theAudio/Video cable.[3] Press [ENTER] to finish this setting.∫ Selecting TV typeChannelSetupDiscVideoAudioDisplayTV ScreenVHSSETUPAspect 4:3 & 480i4:3 TV16:9 Widescreen TVAspect 4:3 & 480pAspect 16:9 & 480iAspect 16:9 & 480pTV TypeENTER4:3 16:94:3 standard aspect TV 16:9 widescreen TVTV TypeYes NoENTERDo you want to use the Component Videooutput connections (Green Blue and Redconnectors) ?Select "No" unless you have the unitconnected to your TV using the three-cable component video connection. If it'sconnected in this way, select "Yes".∫ Removing Interference∫ When you set the RF output channel to “CH3” or“CH4”A picture is output on CH3 or CH4 from RF output.Press [VCR/TV] to switch the mode from TV to VCR, and viceversa.≥When the TV mode is selected, the “TV” indicator lights on theunit’s display and you can watch TV.≥When the “TV” indicator does not light, then the VCR mode isselected and you can watch images from the unit.TV screenPicture with interferenceRF Output ChannelPress the channel up/down buttonsto select a RF Output Channel.Ch. 3ENTERThe unit’s displayThe clear pictureGetting started