Panasonic Diga DMR-EH59EM Operating Instructions Manual

Contents

13RQT9272Tips Auto-SetupAuto-Setup starts instead of “Downloadfrom TV” in the following cases:– when connecting to a television withthe VIDEO OUT, S VIDEO OUT orCOMPONENT VIDEO OUT terminal(¼ 75)– when connecting to a television thatdoes not have the VIERA Link or Q LinkfunctionsThis function automatically tunes allavailable TV stations and synchronizesthe time when the TV channel that isbroadcasting time and date information istuned. This takes about 8 minutes. To cancel setupPress [RETURN]. If the unit displays “No stationsfound !”Press [] to select “No”, then press [OK].Go to step . After you have performedsteps –, turn off the unit and confirmthe cable or aerial input is connectedto the RF IN terminal. Restart the setupagain (¼ 67). If the clock setting menu appears orthe clock is not correct, set the clockmanually (¼ 14). Restarting the setup (¼ 67) To correct the PIN number1. Press [, ] to select the digit.2. Press the numbered buttons to enterthe digit. When this unit is not operated forapproximately 5 minutes while the screenis being displayed, the screen saver maybe displayed.You can turn this function off (¼ 70,“Screen Saver”). to turn the unit on.When connecting to a Q Link compatible TV with a fully wired 21-pinScart cable or a VIERA Link (HDAVI Control 3 or later) compatible TVwith an HDMI cable (¼ 42), downloading from the television starts.– You can download the tuning positions from the television for thechannels in this unit’s channel coverage.– This unit’s Auto Clock Setting function synchronizes the time when the TVchannel that is broadcasting time and date information is tuned.Power SaveOn: Minimise standby powerconsumption, withoutQuick Start function andAV2 loop-through in standby.Off: With Quick Startfunction and AV2 loop-throughin standby.OK RETURNSELECTOnOffPower Save Function:,  to select “On” or“Off”, then OK“On”: It will go into the Power Save mode when the unit is instandby mode.“Off”: It is possible to start quickly from the standby mode.(Quick Start mode)– The features of the power save function when the unit is instandby mode are as below.Power Save On OffPower consumption Approx. 0.9 W Approx. 9 WWatching the picture fromthe digital satellite receiverconnected to the AV2 terminalCannot do Can doStartup time Not quick QuickFront displayTurns off(The clock displaydisappeared.) Stays lighted It is possible to startup and start recording within several seconds.Depending on the type of TV or the connected terminal, it may take time todisplay the screen.When setup has completed, the confirmation screen appears.OKThe Owner ID settings screen appears., then press the numbered buttons toenter your choice of a 4-digit PIN number.Owner IDRETURN : leavePIN number NameHouse No.PostcodeRETURNMake a note of the PIN number(don’t forget), as it is not possibleto return to the factory preset.OK to store the PIN number.(continued on the next page)Preparation: Turn on the mains for the television(and connected equipment) andselect the appropriate AV input tosuit the connections to this unit. These are the first settings you makeupon buying the unit. You don’t needto make these settings again.STATUSCREATECHAPTERRETURNPLAY/x1.3PAUSESTOPSLOW/SEARCHSKIPCHSELECTINPUT0987654321CHAVAATVDRIVESELECTVOLDELETEMANUAL SKIPAUDIO DISPLAYVIDEO Plus+EXITTIME SLIPOKOPTIONPROG/CHECKFUNCTIONMENUDIRECTNAVAIGATAORTV’s remote controlSetting the Channels and ClockQuick Start Guide STEP 3