Panasonic Diga DMR-EH59EM Operating Instructions Manual

Contents

29RQT9272 Advanced Features[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW]Manual RecordingPreparation: ]RAM\ If the disc is protected, release protection(¼ 64). Connect a digital satellite receiver to the “AV2(EXT)” on the unit. (¼ 11). When recording bilingual programmes (¼ 25, Notesfor Recording) When the output signal from the external equipmentis NTSC, change the “TV System” to “NTSC” in theSetup menu (¼ 71).With the unit stoppedSELECTINPUTto select “AV2” for thedigital satellite receiver you haveconnected.DRIVESELECT to select the HDD or DVDdrive.− If you selected the DVD drive, insert a disc(¼ 77).REC MODEto select the recordingmode.Select the channel on the digitalsatellite receiver.RECto start recording.TipsTo skip unwanted partsPress [] to pause recording. (Press again to restart recording.)To stop recordingPress [].Linked timer recordings with externalequipment (SKY Digital STB/satellitereceiver) — EXT LINKPreparation: ]RAM\ If the disc is protected, release protection(¼ 64). Make sure you connect the AV2 terminal of thisunit to “VCR Scart Terminal” of a SKY Digital STB/satellite receiver with a 21-pin scart cable (¼ 11). Set the “AV2 Input” and “Ext Link” to match theconnected equipment in the Setup menu (¼ 71).Make timer programming on SKYDigital STB/satellite receiver.− Refer to the equipment’s operating instructions.DRIVESELECT to select the HDD or DVDdrive.− If you selected the DVD drive, insert a disc(¼ 77).EXT LINK− The unit turns off and “EXT-L” lights on theunit’s display to indicate timer recordingstandby has been activated.− While the unit is in EXT LINK standby modeor recording, most operations on this unit areprohibited ([ OPEN/CLOSE], [/l] etc.).When you operate, press [EXT LINK] tocancel EXT LINK standby mode or recording(The unit turns on and “EXT-L” disappears.).TipsTo cancel the external controlPress [EXT LINK] to stop recording or to cancel linked timerrecording standby (The unit turns on and ‘‘EXT-L” disappears.).Manual timer recordings (¼ 31)Notes In order to prevent accidental operation, press [EXT LINK] tocancel the setting after recording is finished. This function does not work when “TV System” is set to “NTSC” inthe Setup menu (¼ 71). This function does not work with some equipment. Refer to theequipment’s operating instructions. The beginnings of recordings may not be recorded correctly insome cases. Programmes are recorded as one title on this unit when the endtime of the earlier timer recording and the start time of the latertimer recording are close to each other.[HDD] [RAM] To divide the titles, go to “Divide Title” (¼ 45). While the unit is in EXT LINK standby mode or recording, AV1output terminal outputs the signal which is input from the AV2input terminal irrespective of “AV1 Output” setting (¼ 71).To record programmes from a SKY Digital STB/satellitereceiver using timer programmingRecording from a Digital Satellite ReceiverThis unit cannot record NTSC signals to discs thatalready have PAL signal recordings. (However, bothtypes of programmes can be recorded onto the HDD.)