KW2G / KW2G-H Eco-POWER METER756.3.4 Voltage・It displays the voltage value.・Press - △> continuously to shift the display.*When the display is different from the measured load system, set to the correct system at the settingmode. (Refer to 4.2.1 Phase/wire setting mode.)Example of 1P2WR(1)-voltage (V) R(2)-voltage (V)Example of 1P3WR-voltage (V) RT-voltage (V) T-voltage (V)Example of 3P3WRS-voltage(V) RT-voltage (V) TS-voltage (V)・When input voltage is under 5% of rating, it displays ‘0.0’ and doesn’t measure.(‘Under 5%’ means the value getting from this calculation ‘rated voltage 200(400) x 0.05 x VT ratio’.)・When input voltage exceeds 150%F.S. at each range, 「 ‐ ‐ ‐ ‐ ‐ ‐」 will be displayed.・Voltage measurement partsEco-POWER METER measures the voltage as below.DisplaySystem 1.R-V / R-V / RS-V RT-V 2R-V / T-V / TS-VSingle-phasetwo-wireR(1)-voltage(Between P1 and P0)(Line voltage)―R(2)-voltage(Between P2 and P0)(Line voltage)Single-phasethree-wireR-voltage(Phase voltage)RT-voltage(Between P1 and P2)(Line voltage)T-voltage(Phase voltage)Three-phasethree-wireRS-voltage(Between P1 and P0)(Line voltage)RT-voltage(Between P1 and P2)(Line voltage)TS-voltage(Between P2 and P0)(Line voltage)continuouslycontinuously continuouslycontinuously continuously
