Adjusting the lightingYou can adjust the brightness of the camera’s light and configure the light to turn on automaticallyaccording to a schedule or when motion is detected, etc.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired camera.3 Tap [Lighting].R Each setting is explained in this section.Using a scheduleYou can enable the schedule so that the light is turned on and off at specified times and you can alsospecify the light to turn on and off at random times when you are away from home on a vacation, etc.Tap [Use a Schedule] to enable the schedule.R Slide to specify the start time.R Slide to specify the end time.R [Vacation Randomizer]: Turns the light on and off at random times within an hour of the timesspecified in the schedule.Turning on lights after detecting motionYou can enable the light to turn on if motion is detected when it is dark.Tap [Motion Sensor] to enable the use of motion detection to turn on the light.R [Duration]: Determines how the long the light will be lit after motion is detected.Adjusting the brightness of the lightYou can adjust the brightness level for when the light is turned on through a schedule or motion detection.Slide the [Brightness] slider to the desired level.Battery statusWhen backup batteries are used with the camera, you can check the status of the batteries.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired camera.3 Tap [System].R [Battery Status]: Displays the status of the batteries.Note:R When inserting or replacing batteries, disconnect the AC adaptor from the wall outlet before insertingor replacing the batteries. If batteries are inserted or replaced with the AC adaptor connected to a walloutlet, the battery status may not be updated or may be incorrect.64Using a shelf camera and floor camera