– [Very Low]: The image sensor is only slightly sensitive to changes, i.e., a large change is requiredto trigger the sensor.5 When finished, tap [OK].Detection testYou can test which areas of the camera image can be detected while viewing live images from thecamera. This is useful when determining where to install cameras, and also which areas you shouldenable or disable detection for.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired camera.3 Tap [Detection] ® [Detection Test].Video motionA live image of the selected camera is displayed with detection areas colored to show their detectionstatus.– Pink outlined areas: Areas where motion was detected.– Blue outlined areas: Areas where motion was not detected.– Grey areas with a red diagonal line: Areas where detection is disabled. (See “Detection area”,Page 73 for more information.)Temperature sensorYou can configure the camera to send notifications if the camera’s ambient temperature is too cold or toohot.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired camera.3 Tap [Detection] ® [Temperature Alert Range].4 Select the desired temperature for the lower threshold of the acceptable temperature range.5 Select the desired temperature for the upper threshold of the acceptable temperature range, andthen tap [OK].Temperature unitsYou can change the units displayed for the temperature.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired camera.3 Tap [System] ® [Temperature Units].4 Select whether the temperature is displayed and specified in Fahrenheit or Celsius, and then tap[OK].Sound sensitivityYou can configure the sound sensitivity used for sound detection.1 From the [HomeHawk] app home screen, tap ® [Settings].74Using a shelf camera and floor camera