Updating the wireless network SSID information1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Camera Settings] and select the desired device.3 Tap [Home Wireless Network SSID].4 Tap [Update] to update the information.Camera SD cardsSD card capacity and total recording timeThe following recording times apply when images from one camera are recorded. All times areapproximate.– 4 GB card: 4 hours– 8 GB card: 9 hours– 16 GB card: 18 hours– 32 GB card: 36 hours– 64 GB card: 72 hours– 128 GB card: 145 hours– 256 GB card: 290 hoursNote:R SD cards larger than 256 GB cannot be used.R The times listed here are calculated theoretically. Actual recording time may vary.R The times listed here apply during the following condition.– [Resolution] is set to [HD (1280x720)] ( “Changing the camera resolution”, Page 72)R The file system and other information is stored on the SD card, therefore the card’s actual availablecapacity will be less than the card’s noted capacity.SD card formattingBefore inserting an SD card into the camera, format the SD card using your computer and the SDformatting tool available from the web page listed below.{{"www.sdcard.org/downloads/formatter_4/"|tolink("http://www.sdcard.org/downloads/formatter_4/")}}Note:R All data stored on the SD card will be erased when it is formatted.How recordings are saved on the SD cardR Recordings are saved on the camera’s SD card in folders based on the recording date, in the followingpath.– Shelf cameras:/PRIVATE/PANA_GRP/HH/SHELF/MM-DD-YYYY– Floor cameras:/PRIVATE/PANA_GRP/HH/FLOOR/MM-DD-YYYYR The file naming convention is: camera number + recording type + recording start time.– First character: 1 (fixed).– Second character: Recording type. A=sensor recordings, M=manual recordings.– Remaining characters: Recording start time (hhmmss).Example: 1M123455.mp4This file is a manual recording (“M”) that started at 12:34 PM and 55 seconds (“123455”).80Using a shelf camera and floor camera