Note:R In order to use Automatic Mode Switching with the geo-fencing feature, your mobile device must beable to communicate with your camera. Therefore, the mode may not switch automatically in thefollowing situations.– your mobile device and/or your camera do not have good network conditions– your mobile device's battery does not have adequate charge remaining to use the Automatic ModeSwitching featureIn these cases, start the [HomeHawk] app on your mobile device.Turning geo-fencing on and off1 Access the mode screen ( “Accessing the mode screen”, Page 66).2 Under [Automatic Mode Switching], tap [Geo-fence] to turn geo-fencing on or off.Configuring geo-fencingYou can specify the settings to be used with geo-fencing.1 Access the mode screen ( “Accessing the mode screen”, Page 66).2 Under [Automatic Mode Switching], tap .3 Change the settings as required.R Each setting is explained in this section.Setting the base position and radiusIn order to use geo-fencing, you must specify the location and size of the geo-fencing area. The baseposition (usually your home) determines where the geo-fence will be located and the radius determinesthe size of the geo-fencing area.Setting the radius1 Under [Base Position], tap the distance displayed next to [Radius].2 Specify the desired distance, and then tap [OK].Setting the base position for iPhone, iPadOn the map displayed under [Base Position], tap and hold the area you want to specify for the baseposition.Setting the base position for Android devicesTap [Use current location]. The location information of the mobile device is obtained and is used as thebase location. After this, tap [Check Map] and confirm the location displayed on the map.Note:R Although the position can be set using the map, it may not be set accurately.Setting the mode for when you are not at home (out of radius).You can specify the mode that will be used when your mobile device is outside of the specified radiusaround the geo-fencing area (i.e., when you are away from home).This mode will be activated when all of the selected mobile devices ( “Selecting the mobile devices to usewith geo-fencing”, Page 69) are out of the radius.Tap [Out of Radius], select the mode, and then tap [OK].68Using a shelf camera and floor camera