9.11 PBX Configuration—[1-1]Configuration—Slot—V-SIPGW—Port PropertyProgramming Port PropertiesSome of the parameters can be automatically programmed by selecting the desired SIP provider for eachvirtual SIP gateway port.Icon DescriptionIn this section, the following icons show the different parameter type.Icon Description for Parameter TypeProgrammed automatically by selecting the desired SIP provider in Select Provider.Manual programming is compulsory.Manual programming is compulsory under certain conditions.Manual programming is optional.Automatic ProgrammingSome of the parameters on this screen can be automatically programmed by selecting the desired SIP providerfor each virtual SIP gateway port. A maximum of 32 SIP providers can be programmed, and a different SIPprovider can be assigned to each virtual SIP gateway port.Follow the steps below to configure a SIP provider.1. Click Select Provider.A dialogue box will appear. Available virtual SIP gateway port numbers are displayed in the list.2. From the Provider menu, select the desired SIP provider.3. Highlight the desired port numbers or click Select All to select all the virtual SIP gateway port numbers tobe assigned to the SIP provider selected in step 2.4. Click Execute.5. Click OK.6. Click Apply.Appropriate setting values designated by the SIP provider will be set in the parameters for the virtual SIPgateway ports.Manual ProgrammingFollow the steps below to programme the parameters which are not automatically programmed by selecting aprovider.1. Click a desired tab.2. Enter information or select from the list for each parameter.Adding Settings to Provider ProfilesFollow the steps below to add the settings to provider profiles.1. Click Add Provider.A dialogue box will appear. Available virtual SIP gateway port numbers are displayed in the list.2. Highlight the desired port numbers or click Select All to select all the virtual SIP gateway port numbers toadd the settings to provider profiles.3. Click Execute.Trunk AdaptorTo connect to a Trunk Adaptor, follow the steps below.PC Programming Manual 2419.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
