2.1.4 Easy Setup WizardIn the Easy Setup Wizard, you will configure the mandatory settings required for the PBX. When you log in toWeb Maintenance Console for a PBX that is in its initialised, factory default state, the Easy Setup Wizard forthat PBX will launch automatically.You must log in using the Installer level account name and password.– The Installer level account name is "INSTALLER".– The default Installer level account password is "1234".After logging in, the Easy Setup Wizard welcome screen is displayed. Select a language, and then clickInstall.1. In Location Setting:a. Select a PBX Type:• Master: Select for a PBX that will be registered as the Master unit of One-look Network. Also selectfor a stand-alone PBX that will not be used in a One-look network.• Slave: Select for a PBX that will be registered as a Slave unit of a One-look network. If Slave isselected, go to step 1-d below.Note• If the Master unit is located on a different LAN than the Slave unit being registered, theSlave unit will not be able to automatically detect the Master unit for registration. The IPaddress of the Master unit must be specified. Enter the IP address of the Master unit in Iflocated on different network from Master PBX.• For information about stand-alone systems and One-look networks, refer to "1.2.3 PBXConfiguration Types".b. Select a Suffix Code from the drop-down list if Master is selected for PBX Type.c. Select an Area from the drop-down list if Master is selected for PBX Type.d. Click Next.NoteIf Suffix Code is changed from its default value, a notice about restarting the PBX is displayed. ClickOK to restart the PBX. After the PBX restarts, start Web Maintenance Console again (see1.2.1 Starting Web Maintenance Console). When you start the Easy Setup Wizard again, you willstart from step 2, below.2. In PBX Setting:a. Specify a Site name if Master was selected for PBX Type in step 1.b. Select a Time Zone from the drop-down list.c. Click the Local Time box and select the date and time from the menu.d. Select the default value of Numbering Plan from below.– 3 digits Extension Number (This type is recommended for under 8 sites)– 4 digits Extension Number– 3 digits Extension, 4 digits DISA & UM channelNoticeDepending on the value selected above, the numbering plan of the PBX will vary as follows. Beaware that the default values for floating extension numbers and the number of available UM groupsare different.PC Programming Manual 432.1.4 Easy Setup Wizard
