3.1.2 Programming WaysUser Programming (Manager Programming) 3-5Advancing to the next stageWhen “MNG-PGM NO?->” is displayed, you can select one of the following:• To go to program [000], press the NEXT button.• To go to another program, enter the 3-digit program address.Rotation of jack numberEach jack of our Digital Super Hybrid System supports the connection of a proprietarytelephone and an analog device with different extension numbers (eXtra Device Port: XDPfunction).To program this function it is necessary to assign two parts for each jack. The first part of jackone is 01-1. The second part of jack one is 01-2. The first part of jack two is 02-1 and so on.The NEXT and PREV buttons can be used to move from jack to jack as required.Example;#01-1 #01-2 #02-1 #02-2......Note:The first part of a jack is for a PT of a XDP-assigned jack. The second part is for a single linedevice. Program [600] “EXtra Device Port” assigns which jacks are XDP.Entering CharactersYou can enter characters to store names for speed dial numbers, extension numbers, etc., byusing the dialing key pad and the buttons.Each of twelve dialing keys on the dialing key pad has seven characters assigned. Refer to the“Station Speed Dialing Number / Name Assignment (KX-T7235 only)” section in Section 2.2Programming.Storing your dataPress STORE to store your data.• The STORE indicator lights red and confirmation tone sounds.* Confirmation tone (one beep)After pressing STORE, you will hear a beep. This informs you that your storage iscompleted.*Alarm tone (three beeps)If you hear the alarm, check that your entry is valid.Making another selection within the same program address• To make the next higher selection, press NEXT.• To make the previous selection, press PREV.• To make a specific selection, press SELECT and then enter the number.PREVNEXTPREVNEXTPREVNEXT
