Connecting to other equipment112VQT0X92Connecting to other equipmentConnecting to a PCYou can acquire recorded pictures to a PCby connecting the camera and the PC.The software [LUMIX Simple Viewer] or[PHOTOfunSTUDIO-viewer-](for Windows ®) in the CD-ROM (supplied)allows you to easily acquire picturesrecorded with the camera to a PC, printthem and send them by e-mail.If you use “Windows 98/98SE”, installthe USB driver and then connect it tothe computer.For information about installing [LUMIXSimple Viewer] or[PHOTOfunSTUDIO-viewer-] etc., refer tothe separate operating instructions for PCconnection.: USB connection cable (supplied): AC adaptor (DMW-AC7; optional)• Use a battery with sufficient battery poweror the AC adaptor (DMW-AC7; optional).• Turn the camera off before inserting orremoving the cable for the AC adaptor(DMW-AC7; optional).1 Turn on the camera and the PC.2 Connect the camera to a PC viathe USB connection cable (supplied).• Connect the USB connection cable withthe [ ] mark facing the [] mark onthe [DIGITAL] socket.• Hold the USB connection cable at and insert straight in or take straightout. (If you forcibly insert the USBconnection cable at a slant or upsidedown you can deform the connectionterminals and damage the camera orthe connected equipment.): This message appears during datatransfer.3 Press to select [PC] and thenpress [MENU/SET].• If you set [USB MODE] in the [SETUP]menu to [PC] in advance, it is notnecessary to set this every time youconnect to a PC. (P30)• If you set [USB MODE] to [PictBridge(PTP)] and then connect the camera tothe PC, messages may appear on thescreen of the PC.Select [Cancel] to close the messagesand disconnect the camera from thePC. Set [USB MODE] to [PC] again.REMOTEDC IN 8.4VAV OUT/DIGITALACCESSUSB MODESELECT SET MENUPictBridge(PTP)PCPLEASE SELECTTHE USB MODESETMENU
