Chapter 4 Settings — [SIGNAL LIST] menuENGLISH - 103Sub memoryThe projector has a sub memory function that can register the multiple image adjustment data, even if it is recognized as the same signal bythe frequency or format of the synchronization signal source.Use this function when you need to adjust the picture quality such as switching of the aspect ratio or white balance by the samesynchronization signal source. The sub memory includes all the data that can be adjusted for each signal, such as the screen aspect ratio anddata adjusted in the [PICTURE] item ([CONTRAST], [BRIGHTNESS], etc.).Registering to the sub memory1) Press as on the normal screen (when the menu is not displayed).f The sub memory registration screen is displayed if the sub memory is not registered. Proceed to Step 3).f A list of sub memories registered to the signal currently input is displayed.f By selecting [SUB MEMORY] in the [PROJECTOR SETUP] menu → [FUNCTION BUTTON], the button on the remotecontrol can be used instead of qw.2) Press asqw to select the sub memory number to register in [SUB MEMORY LIST].3) Press the button.f The [SIGNAL NAME CHANGE] screen is displayed.4) Press asqw to select [OK], and press the button.f To rename the registered signal, follow the procedure in Steps 6) and 7) in “Renaming the registered signal” (x page 101).Switching to the sub memory1) Press as on the normal screen (when the menu is not displayed).f A list of sub memories registered to the signal currently input is displayed.2) Press asqw to select the signal to switch in [SUB MEMORY LIST].3) Press the button.f This switches to the signal selected in Step 2).Deleting the sub memory1) Press as on the normal screen (when the menu is not displayed).f The [SUB MEMORY LIST] screen is displayed.2) Press asqw to select the sub memory to delete, and press the button on the remotecontrol.f The [REGISTERED SIGNAL DELETE] screen is displayed.f To cancel the deletion, press the [SUB MEMORY LIST] screen.3) Press the button.f The selected sub memory will be deleted.