Panasonic PT-EZ580 Operating Instructions Manual

Also see for PT-EW540: Operating instructions (functional manual)

Contents

Panasonic PT-EZ580 Operating Instructions Manual Manual pdf 143 page image

Chapter 6 Appendix — Technical informationENGLISH - 143r Projector control command (with sub command)Command Sub command Details RemarkVXX LPWI1 Lamp power selection +00001=NORMAL,+00000=ECO, +00030=AUTOVXX RYCI2 RGB2 input setting +00000=RGB/YPBPR, +00001=Y/C, +00002=VIDEOr Lens control commandCommand Sub command Details RemarkVXX LNSI2 Lens H shift+00000=Fine adjustment 1+, +00001=Fine adjustment 1-,+00100=Fine adjustment 2+, +00101=Fine adjustment 2-,+00200=Coarse adjustment+, +00201=Coarse adjustment-VXX LNSI3 Lens V shiftVXX LNSI4 Lens focusVXX LNSI5 Lens zoom terminalIt is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote controlsignals cannot reach.Use the terminal on the connecting terminals of the projector to connect to the control panel.Remote control Contact controlRemote control/contact controlStandby LitLampRGB1 VIDEORGB2 HDMIDVI-DInstallation locations in meeting rooms, etc. Remote control board in another locationPin assignments and signal namesD-Sub 9-pinOutside view Pin No. Signal name Open (H) Short (L)(9) (6)(5) (1)(1) GND ― GND(2) POWER OFF ON(3) RGB1 Other RGB1(4) RGB2 Other RGB2(5) VIDEO Other VIDEO(6) HDMI Other HDMI(7) DVI-D Other DVI-D(8) SHUTTER *1 OFF ON(9) RST/SET Controlled by remotecontrolControlled by externalcontact*1 For PT-EZ580, PT-EW640 and PT-EX610[AV MUTE] for PT-EW540 and PT-EX510Attentionf When controlling, make sure to short-circuit pins (1) and (9).f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands forRS-232C and network functions corresponding to these functions are also disabled.g Power <v/b> button on the control panel or the power on <b> button, power standby <v> button, and button and MUTE> button on the remote controlf When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on thecontrol panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are alsodisabled.