Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 45Notef While the power indicator is lit in orange, the fan is running to cool the projector.f For about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators do not light up even ifthe power is switched on. After the power indicator lights in red, turn on the power again.f The projector consumes power even in standby mode (power indicator lit in red). Refer to “Power consumption”(x page 149) for the power consumption.f The power indicator will flash if the projector receives a remote control signal.f The power indicator will flash slowly in green while the shutter is closed or AV mute function is used.f If the power indicator is flashing in red, consult your dealer.Switching on the projectorWhen using the optional Projection Lens, attach the Projection Lens before switching on the projector.Remove the lens cover first.2)4)4)3) 1)1) Connect the power cord to the projector body.2) Connect the power plug to an outlet.f (AC 100 V - 240 V, 50 Hz/60 Hz)3) Press the side of the switch to turn on the power.f After a short while, the power indicator will light in red, and the projector will enter the standby mode.4) Press the power <v/b> button on the control panel or the power on <b> button on the remote control.f The power indicator lights in green and the image is soon projected on the screen.Notef If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longerbefore the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.f If the switch was set to during projection to end the projection using the direct power off function last time, and the switch is set to with the power plug connected to the outlet, the power indicator will light ingreen and the image will soon be projected on the screen.When the initial setting screen is displayedWhen the projector is switched on for the first time after purchase as well as when [ALL USER DATA] in the [PROJECTOR SETUP] menu →[INITIALIZE] is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen is displayed. Set themin accordance with circumstances.In other occasions, you can change the settings by menu operations.Focus adjustmentAdjust the focus to display the menu screen clearly.You may also need to adjust the zoom and shift.Refer to “Adjusting the focus, zoom, and shift” (x page 49) for details.1) Press asqw to adjust the focus.LENSFOCUSADJUST2) Press the
