Panasonic WJ-HD200 Operating Instructions Manual

Also see for WJHD200 - Digital Disk Recorder: Operating instructions

Contents

Panasonic WJ-HD200 Operating Instructions Manual Manual pdf 25 page image

25■ Main Menu WJ-HD200 MAINMENUThe main menu is located in the top of the menu tree fromwhere every menu window starts.1. Hold down the [SETUP/ESC] button for 2 seconds. Themain menu appears.2. Select a setup menu you wish to program using the [D]or [C] button, and press the [SET] (JogDial).The selected setup menu opens. The following pageswill detail each setup menu.■ Timer Recording Setup TIMERRECThis menu assigns a timer to start recording by use of anexternal timer or the internal timer. When the internal timer(INT) is set, there are four programs assignable to theweekly and/or daily schedule. Each program can containup to four events along with start and end time, recording-mode. Alarm recording will be carried out when an alarmoperates during the scheduled time zone.When the external timer (EXT) is set and the connectedtimer switch turns on to supply power, the recorder will startpower-on recording.1. Select a timer mode using the JogDial.OFF: Does not use any timer, and manual recording isavailable.INT: Carries out internal timer recording according tothe program.EXT: Carries out power-on recording.2. Press the JogDial to validate the selection. When INT isselected, the TIMER REC menu opens.3. Move the cursor to the desired line using the [D] or [C] button.4. Select a program number from among PROGRAM 1 toPROGRAM 4 using the JogDial, and press the JogDial.The PROGRAM “1-4” SETUP menu opens.● Program “1-4” Setup PROGRAM “1-4” SETUP1. Select the event number with the [D] or [C] button,and press the JogDial. The cursor moves to the STARTposition.After this operation, the [D] and [C] buttons move thecursor to the right and left.2. Select a start time (START) using the JogDIal, andpress the [D] button to move the next position.Available START time: From 0:00 to 23:59 in the 24-hour system.3. Select an end time (END) in the same way as aboveand press the [D] button to move the cursor to theMODE position.Available END time: From 0:01 to 24:00 in the 24-hoursystem.Notes: There are some restrictions on programming.• An event, except the first event (NO 1), can be pro-grammed only if the immediately preceding eventhas been set up.• A start time should be late than the end time of theimmediately previous event.• An end time should be late than the start time of theevent.• An end time 24:00 will cancel all the followingevents.4. Press the JogDial while the cursor is on SETO to openthe event programming menu.WJ-HD200 MAIN MENUTIMER OFFOREC SETUPOEXT REC SETUPODISPLAY SETUPOSYSTEM SETUPOALARM SETUPOCOMMUNICATION SETUPOSWITCHER SETUPOSYSTEM INFORMATIONOPROG1 SETUPNO. START END MODE1→ 8:00 12:20 SETO2→ 13:00 15:00 SETO3→ : :4→ : :TIMER RECPROGRAMSUNDAY PROG1OMONDAYTUESDAYWEDNESDAYTHURSDAYFRIDAYSATURDAYDAILY