Panasonic WJ-HD200 Operating Instructions Manual

Also see for WJHD200 - Digital Disk Recorder: Operating instructions

Contents

Panasonic WJ-HD200 Operating Instructions Manual Manual pdf 58 page image

59at a time. The status display will indicate as“* → PLAY” while playing back the images record-ed with a changed rate from the preset.• Suffix “xxx” following “SP-“ is specified in RECMODE TABLE in ADDENDUM attached to the man-ual.1. Select a recording mode. Audio data will be recordedwhen a mode with hyphen A is selected.Available Recording Mode: SF, FQ, NQ, EX, SP, SF-A,FQ-A, NQ-A, EX-A, and SP-A.2. When SP or SP-A is selected, specify a recording rate(REC RATE).Available Recording Rate: From 0.1 to 30 FPS3. When SP or SP-A is selected, specify a recording quali-ty (REC QUALITY).Available recording quality: SUPER FINE, FINE, NOR-MAL, EXTENDED● Alarm Recording Mode Setup ALMREC MODEAlarm events arising within the time zone specified by theprogram will start recording with the preset parameters.Refer to “PROG NO. SETUP” described above for operatingprocedures, and available parameters, since they are verymuch similar.● Pre-alarm Recording PRE ALM RECAvailable Time (seconds): 0S, 1S, 2S, 3S, 4S, and 5S● Post-alarm Recording POST ALMRECAvailable Time (Second): 5, 10, 20, 30Available Time (Minute): 1, 1.5, 2, 3, 6Manual: Recording continues until the [REC STOP] but-ton is pressed, or RESET IN signal is supplied to therear panel.Continue:Recording continues while the alarm input isactive, or at least for 10 seconds if the input earlyturns inactive.● Dynamic Recording DYNAMIC RECALM-MULTI: Alarm activated channels are recorderwith priority over others.OFF: All channels are evenly recorded.■ Trigger Action Setup TRIGGERACTION SETUP8 Mode (MODE)OFF: Disables alarm recording, logging, or warning.REC&ALARM: Enables all alarm recording, loggingand warning.REC: Enables alarm recording and logging, but dis-ables warning.Click the [SET] button if all are adequately set.■ Camera Recording Setup CAMREC SETUPClick the CAMERA REC SETUP in the system setupwindow to open the menu.This menu is provided for the purpose of disk spacesaving. Each camera channel can be recorded onlywhen an alarm operates while it will not be recordedduring non-alarm status.ALARM-ONLY: Records the camera channel onlywhen the alarm operates.