Panasonic WJ-HD200 Operating Instructions Manual

Also see for WJHD200 - Digital Disk Recorder: Operating instructions

Contents

Panasonic WJ-HD200 Operating Instructions Manual Manual pdf 27 page image

27● Post-alarm Recording POST ALMRECThis setting specifies the duration of alarm recording afteran alarm input. Functions active during alarm recording arebuzzer beeping, ALARM LED indication, "ALARM" statusdisplay, and the ALARM OUT signal.1. Move the cursor to POST ALARM REC with the [D] or[C] button.2. Select the desired duration with the JogDial.The default value is 10 seconds.The unit will revert to the previous status when the timehas elapsed.Available Time (Second): 5, 10, 20, 30Available Time (Minute): 1, 1.5, 2, 3, 6Continue: Recording continues until the [REC STOP]button is pressed, or RESET IN signal is supplied tothe rear panel.Manual:Recording continues while the alarm input isactive, or at least for 10 seconds if the input earlyturns inactive.● Dynamic Recording DYNAMIC RECThis setting specifies recording pattern on the disk whenone or more alarm operate.1. Move the cursor to DYNAMIC REC with the [D] or [C]button.2. Select the parameter with the JogDial, and press theJogdial.The default is OFF.ALM-MULTI: Alarm activated channels are recordedwith priority over others.OFF: All channels are evenly recorded.● Trigger Action Setup TRIGGERACTION SETUPThis setting specifies two roles of the alarm recording andalarm control functions (Refer to page 44) in the post-alarmsequence.1. Move the cursor to TRIGGER ACTION SETUPO, andpress the JogDial.The TRIGGER ACTION SETUP menu opens.2. Move the cursor to the channel.3. Select the parameter with the JogDial, and press theJogdial.The default is REC&ALM.OFF: Disables alarm recording or warning.REC&ALM: Enables both alarm recording and warning.REC: Enables alarm recording, but disables warning.4. Repeat steps 2 and 3 until all channels are set.5. Press the [SETUP/ESC] button to return to the PROG“1” NO. “1” SETUP menu.● Camera Recording Setup CAM RECSETUPThis setting is provided for the purpose of disk space sav-ing. Setting allows each camera channel to be enrolled inall recording modes or exclusively in alarm recording.1. Move the cursor to CAM REC SETUP, and press the[SET] button. The CAM REC SETUP menu opens.2. Move the cursor to the camera channel with the [D] or[C] button.3. Select the parameter with the JogDial, and press theJogDial.The default is REC.REC: The channel is recorded in alarm recording, timerrecording and manual recording mode.ALM-ONLY: The channel is recorded only when thealarm operates.4. Repeat steps 2 and 3 until all channels are set.5. Press the [SETUP/ESC] button to return to the PROG“1” NO. “1” SETUP menu.CAM REC SETUPCAM MODE1 REC2 REC3 REC4 ALM-ONLY5 REC6 ALM-ONLY7 REC8 RECTRIGGER ACTION SETUPCAM MODE1 OFF2 OFF3 OFF4 REC&ALM5 REC6 OFF7 OFF8 OFF