39● IP Address IP ADDRESSThe default is “192.168.000.010”.● Netmask NETMASKThe default is “255.255.255.000”.● Gateway GATEWAYThe default is “192.168.000.001”.■ Switcher Setup SWITCHERSETUPVideo switcher functions are programmed in this menusetup.● Start Display START DISPLAYThe image in the selected form will be displayed on themonitor when the recorder is turned on.Single Image: CH 1 to CH 8Quad Image: QUAD-4A (including 1-4), QUAD-4B(including 5-8)Multi Image: 9SCREEN (including 1-8)Sequence: SPOT SEQ, MULTI SEQ● Multiscreen Selection MULTI SELMODEWhen the [MULTI SCREEN SEL] button on the front panel ispressed, the monitor display will change as followsdepending on the selection.QUAD ONLY: QUAD-4A → QUAD-4B → QUAD-4AALL: QUAD-4A → QUAD-4B → 9SCREEN → QUAD-4A● Sequence Setup SEQUENCE SETUP1. Move the cursor to SEQ SETUP in the SWITCHERSETUP menu, and press the JogDial.The SEQ SETUP menu opens.2. Select either MULTI SEQ SETUP or SPOT SEQ SETUPwith the [D] or [C] button, and press the JogDial. Theselected menu opens.● Multiscreen Sequence Setup MULTISEQ SETUPOpen the QUAD SEQ SETUP menu to program thesequence steps for displaying quad-split and single inputimages.1. Move the cursor to the desired step using the [D] or[C] button.2. Select a camera number with the JogDial, and pressthe JogDial.The default camera number is identical to the step num-ber.Available camera: From 1 to 8 individually, 4A(1-4), or4B(5-8)Note: The recorder will skip the step you assigned “–”.3. Select duration for the step with the JogDial, and pressthe JogDial.Available duration: 2-30 SSWITCHER SETUPSTART DISPLAY QUAD-4AMULTI SEL MODE ALLSEQUENCE SETUPOCAMERA VIEW SETUPOSEQUENCE SETUPMULTI SEQ SETUPOSEQUENCE TIMING INTAUTO SKIP ONSPOT SEQ SETUPOSEQUENCE TIMING INTAUTO SKIP ONMULTI SEQ SETUPSTEP CAM SEC1 → QUAD-4A 2S2 → QUAD-4B 2S3 → - 2S4 → - 2S5 → - 2S6 → - 2S7 → - 2S8 → - 2S