38● Camera Number Setup CAM NO.SETUP (exclusive for PS • DATA)Camera numbers will be used in a PS•DATA chain whenyou select the desired camera to control it, operating on asystem controller.1. Move the cursor to CAM NO. SETUPO with the [D] or[C] button, and press the JogDial. The CAM NO.SETUP menu opens.2. Move the cursor to the desired line with the [D] or [C]button.3. Select the number with the JogDial, and press theJogDial.The default number is the same as the CAM-PORTnumber.Assignable number: From 001 to 128, each numbermust be unique in the chain.4. Press the [SETUP/ESC] button to go back to the SERI-AL SETUP.■ Network Setup NETWORKSETUPNote: The system will restart after the menu setup windowis closed when any parameter in this window has beenchanged.● Line Speed LINE SPEED1. Move the cursor to LINE SPEED with the [D] or [C]button.2. Select the parameter with the JogDial, and press theJogDial.The default is AUTO.AUTO: The speed is automatically selected.100M_FULL: 100 mega byte, full duplex100M_HALF: 100 mega byte, half duplex10M_FULL: 10 mega byte, full duplex100M_HALF: 10 mega byte, half duplex● HTTP Port HTTP PORTSet an HTTP port number.The default is 80.Available Port Number: From 00000 to 65535● Host Name HOST NAMEA maximum of 10-digit host name is entered using alphanu-meric and symbols.The default is WJ-HD200••.● Dynamic Host Configuration ProtocolDHCPDynamic Host Configuration Protocol is enabled or dis-abled.The default is OFF.Note: When ON is selected, you cannot enter IPaddress, netmask, or gateway. The host gives theseparameters.The given parameters will be displayed after gettingIP address from the DHCP server.CAM NO.SETUPCAM-PORT CAM NO.1 0012 0023 0034 0045 0056 0067 0078 008NETWORK SETUPLINE SPEED AUTOHTTP PORT→ 00080HOST NAME→ WJ-HD200••DHCP OFFIP ADDR →192.168.000.010NETMASK →255.255.255.000GATEWAY →192.168.000.001