Panasonic aw-he40 series Operating Instruction

Also see for aw-he40 series: Installation & setup guide Quick start guide Quick start guide Manual Quick start guide

Contents

7How to turn the power on and off■Turning the power onWhen performing the operationsusing the wireless remote control1 Set all the power switches of the units anddevices connected in the system to ON.● The unit does not have a power switch.When power is supplied to it, the status display lampwill light up orange.2 Press one of the [CAM1] to [CAM4] buttons onthe wireless remote control to select the unit.3 Press the [ON/STANDBY] button on thewireless remote control for 2 seconds.The POWER ON mode is established, images areoutput, and control can be exercised.● The unit’s status display lamp now lights up green.● It takes about 30 seconds per unit for the initialsettings operation to be completed. During thisperiod, the unit cannot be operated.● The unit stores its STANDBY / POWER ON modestatus in the memory.● If the power supply is cut off while the operation isin POWER ON mode, the operation will transferredto the POWER ON mode the next time power issupplied.● When transferring to the STANDBY mode(Status display lamp: Orange)The pan/tilt position is stored in the memory, and thepan/tilt unit is moved so that it points backwards.● When transferring to the POWER ON mode(Status display lamp: Green (after the initial settingoperation is completed))The pan/tilt unit is moved to the position which wasstored in the memory when the transition to theSTANDBY mode was made.● POWER ON presetThe pan/tilt unit is moved to the setting, which wasestablished immediately prior to the transition to theSTANDBY mode, when the power has been turnedon.● If the power is turned off without transferring to theSTANDBY mode, the pan/tilt unit position will notbe stored in the memory or reflected in the POWERON preset. The previous POWER ON preset will beapplied.Notes4 If a multiple number of units are going to beused, repeat steps 2 and 3 as required.The unit’s status display lamp blinks green when a signalmatched by the remote control ID has been received, andit blinks orange when a signal that is not matched by theremote control ID has been received.■Turning the power offWhen performing the operationsusing the wireless remote control1 Press one of the [CAM1] to [CAM4] buttons onthe wireless remote control to select the unit.2 Press the [ON/STANDBY] button on thewireless remote control for 2 seconds.The unit enters STANDBY mode.● The unit’s status display lamp now lights up orange.3 If a multiple number of units are used, repeatsteps 1 and 2 as required.4 Set all the power switches of the units anddevices connected in the system to OFF.When performing the operations using the controllerWhen using an AW-RP50, AW-RP120 or AK-HRP200:Refer to the Operating Instructions of the controller.